2. Buckeyestargazer
  3. EAF-GSO-2LBF
EAF-GSO-2LBF

Buckeyestargazer EAF-GSO-2LBF Installation guide

  • Hello! I've reviewed the installation instructions for the Buckeyestargazer focuser bracket. This document covers the steps to install the EAF bracket onto your GSO linear bearing focuser, including using the correct hex keys, a coupler, and securing the device correctly. I am ready to answer any questions you have about the installation process.
  • What tools are needed for installation?
    What size are the screws used to secure the bracket to the focuser?
    What screws are used to attach the EAF to the bracket?
GSO Linear Bearing Focuser EAF bracket
Installation Instructions
(EAF-GSO-2LBF / EAF-GSO-3.25LBF)
Tools needed: 1.5mm hex key, 2.5mm hex key
Please follow carefully!
1. With the bottom of the focuser pointing up to avoid falling, remove the 4 focuser housing
screws.
2. Locate included (4) M3x14mm socket head screws. Using the 2.5mm hex key, secure the bracket
to the focuser by evenly tightening all 4 screws until they are snug. Tighten 1/4 turn more, being
careful to tighten all 4 screws evenly.
3. Slide the coupler onto the focuser pinion shaft.
4. Attach the EAF to the bracket using M4 screws supplied by ZWO with the EAF.
5. Using the 1.5mm hex key, tighten the set screws on the coupler until they are snug. Do not over
tighten.
/