Rust-Oleum Restore 51750 User manual

Type
User manual
TECHNICAL DATA RST-05
RESTORE
CRACK FILLER
Form: GDH-187
Rev.: 100515
1
DESCRIPTION AND USES .
Restore
Crack Filler is a high performance crack filler for filling
cracks up to ⅜” deep. The advanced formula is lightly textured
and provides maximum adhesion to wood, composite decking,
concrete and masonry to diminish or erase cracks when used
with Restore 10X Deck & Concrete. Restore Crack Filler is
suitable for use on wood and composite decks, concrete patios,
walks and steps. It adheres well to painted and unpainted wood,
concrete and masonry.
.PRODUCTS .
SKU Description
51750 10 oz cartridge
..PRODUCT APPLICATION .
SURFACE PREPARATION
Proper surface preparation is critical to performance. Surface
must be clean and free of dirt, grease, mildew and organic
growth to ensure product bonding and adhesion. Sand or scrape
any loose paint and remove any old, unsound caulk.
..PRODUCT APPLICATION (cont.)
DIRECTIONS
1. Before using, surface must be dry and free of dirt, dust, old
caulk and grease.
2. Clip off tip of spout at a 4 to desired size.
3. Load cartridge into caulking gun and apply.
4. Smooth for a neat appearance.
5. Wipe away excess with a damp cloth before surface skins
over.
6. Protect from water until cured (72 hours). May be coated with
Restore 10X Deck & Concrete in 4-6 hours depending on
climatic conditions. Larger beads may require longer drying
time.
RECOMMENDATIONS:
Joint depth should not exceed ”.
Expect one cartridge to caulk 50 feet when the bead is 3/16.
Avoid use in marine environments and other below-grade areas.
Keep from freezing.
Prime bare surfaces before caulking.
For best results, sealant and surface temperature should be
between 40˚F and 90˚F when applied.
CLEAN-UP
When finished, wash tools and equipment with mild soap
and warm water. Properly dispose of all soiled rags and
protect unused product from freezing.
TECHNICAL DATA
RESTORE
CRACK FILLER
Rust-Oleum Corporation Form: GDH-187
11 Hawthorn Parkway Phone: 877•3858155 Rev.: 100515
Vernon Hills, Illinois 60061 www.rustoleum.com
An RPM Company
PHYSICAL PROPERTIES .
* Beads larger than 3/16 may require more time.
CRACK FILLER
Resin Type
Water-based Acrylic
Pigment Type
Calcium Carbonate and Silica
NoneNone
Solvents
Glycol Ethers, Water
Volatile Organic Compounds
<25 g/l (<1.5% by weight)
Practical Coverage at Recommended
DFT
Approximately 50 linear feet
Dry Times at 70-80°F
(21-27°C) and 50%
Relative Humidity
Recoat
4-6 hours
Full Cure
72 hours
Specifications
Meets ASTM C834
Shelf Life
5 years
Flash Point
>200ºF (93ºC)
Safety Information
For additional information, see the SDS
The technical data and suggestions for use contained herein are correct to the best of our knowledge, and offered in good faith. The statements of this literature
do not constitute a warranty, express, or implied, as to the performance of these products. As conditions and use of our materials are beyond our control, we
can guarantee these products only to conform to our standards of quality, and our liability, if any, will be limited to replacement of defective materials. All
technical information is subject to change without notice.
  • Page 1 1
  • Page 2 2

Rust-Oleum Restore 51750 User manual

Type
User manual

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI