M 6*1 5 B O L T
P A R T S LIS T
D E S C R I P T I O N
Q T Y .
A
B
C
D
E
F
8
4
11
W A S H E RW A S H E R
B O L T C O VERB O L T C O VER
A LLE N W REN C HA LLE N W REN C H
1
T A B L E T O P
1
1 6
1 6
T ABL E LEG
G
L EG C O N NECTOR
B RAC K E T
H
G
D
F
G
D
F
A
C
B
I
8
2
G
E
F
G
E
F
H
T I L E
F I G . 1
F I G . 2
FIG. 3
M 6 * 2 5 B O L T
Step 1: Place the table top (A) upside down on a soft,
non-abrasive surface. Line up bolt holes on table leg (C)
with corresponding bolt holes on the underside of the table
top (A). Screw the M6*15 bolt (D) with washer (F) with
Allen wrench (I). Do not completely tighten bolts. See
Figure 1 above. Repeat this step until all four table legs
are attached to the table top.
Step 2: Place the leg connector bracket (B) between the
table legs (C). Line up bolt holes on the leg connector
bracket (B) with corresponding bolt holes on the table
legs (C). Screw the M6*25 bolts (E) on with washer (F)
using an Allen wrench. See figure 2 above. Repeat this
step until all four table legs are connected to the table
connector bracket.
Make sure all bolts (D & E) are completely tighten. Place
bolt cover (G) on the head of all bolts (D & E).
Step 3: Now turn the table in an upright
position on a flat surface. Carefully place the
tiles (H) on table top (A). See Figure 3 above.
Thomas 4 pc Casual Set Assembly Instruction
JDT-2032-2744 table
2
See our extensive assortment of outdoor living products on-line at www.sears.com and www. kmart.com.