Hagerco 33E - Pull Plate - Square Corner - 30S Plate, 3E Pull Installation guide

33E PULL PLATE

INSTALLATION INSTRUCTIONS

I-TA01242

Rev -, Rev Date: 11/18/2019 Page 1 of 1

1. Determine mounng height on door (Recommend center of the plate is 45” [1143 mm] from the

oor)

2. Place the plate on the door so that the edge of plate is 1.5” [38 mm] from edge of door.

3. Once plate is in the desired posion on the door, mark (6) holes for drilling

4. Center punch and drill (6) 1/8” pilot holes.

5. Install the plate using (6) thread cung screws.

TOOLS REQUIRED