©2019 Jones Stephens Corporation
www.jonesstephens.com
C06011
1-3/4 in. O.D. Faucet Hole Cover
INSTALLATION INSTRUCTIONS
1. Remove nut from new faucet hole cover.
2. From the top of the sink, insert shank of faucet hole cover into the hole in the
sink. Center top of faucet hole cover over the hole.
3. From underside of the sink, thread nut onto shank. Thread until secure. Do not
over-tighten.
-
1
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI