Union Corrugating ST-RR-1000-048 Operating instructions

Brand: Union Corrugating

Model: ST-RR-1000-048

Type: Operating instructions

This manual is also suitable for

15652

GALVANIZED RIDGE ROLL (RC-3)

R 1¼ in.

3.175 cm

4.44 cm

7.3 cm

6.35 mm

1 ¾ in.

2 7⁄8 in.

¼ in.

135° 135°

135°

Ridge Roll Ridge flashing for metal roofing and shingle roofs hips & ridges

Material: Ridge Roll ridge caps are made from galvanized coated steel for added corrosion

protection. Manufactured to last the life of the structure.

Installation: The ridge roll ridge cap is placed on top of pre-glued closure strips (outside) and

fastened by # 9 x 1 ½" metal roofing screws in an opposing manor directly across from each

other into the high rib of the panel approx. 6" O.C.

10' lengths. 10 per bundle.

The ridge roll tops off differently than others, but still provides an unchanging classic look and

commitment in shedding rain water.

INSTALLATION GUIDELINES

These installation guidelines are for use with typical or standard applications. Refer to SM-Rib installation guide for panel and flashing install details. It is

always recommended to seek advice from a licensed professional, and to check with your local building inspector or building permit office for approvals and

possible variations that may apply.

CAUTION!

Working above grade is inherently dangerous, be sure that proper fall protection measures are in place.

When working with power tools and sheet metal, gloves and eye protection are absolutely required.