3M Adper™ Single Bond Plus Adhesive Intro Kit, 51101 User guide

Type
User guide

This manual is also suitable for

DIRECT LIGHT-CURE RESTORATION
Adper
Single Bond Plus Adhesive
3
4
1 of 1
1
2
Etch:
• Apply Scotchbond
Etchant to enamel
and dentin. Wait 15 seconds.
• Rinse for 10 seconds.
• Blot excess water using a cotton pellet
or mini-sponge. Do not air dry.
The surface should appear glistening
without pooling of water.
Adhesive:
Immediately after blotting, apply 2-3
consecutive coats of adhesive for 15
seconds with gentle agitation using a
fully saturated applicator.
• Gently air thin for 5 seconds to
evaporate solvent.
Light-Cure:
• Light-cure for 10 seconds.
Restorative:
• Place restorative according to
manufacturer specifications.
3M ESPE Customer Hotline 1-800-634-2249 70-2009-3630-3
Please refer to instructions for more detailed information 44-0007-4208-8
as well as precautionary and warranty information. Used under license in Canada. © 2004 3M
3M, ESPE, Adper, and Scotchbond are trademarks of 3M or 3M ESPE AG.
  • Page 1 1

3M Adper™ Single Bond Plus Adhesive Intro Kit, 51101 User guide

Type
User guide
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI