3
1 - OPEN THE FRAME
2 - INSERT AND REMOVE OF FRONT WHEELS
To remove the wheel, pull the lever in direction arrow shows and take the wheel out of the frame.
3 - INSERT AND REMOVE OF REAR WHEELS
To remove the wheel, pull the lever in direction arrow shows and take the wheel out of the frame.
4 - ASSEMBLY OF CANOPY
Note: Before using the stroller, make sure that the zipper is closed.
5 - INSERT AND REMOVE OF FRONT BUMPER BAR
To remove the front bumper bar, press the buttons and pull the bumper bar out of the frame.
6 - INSTALLATION OF SEAT
To remove the seat, press the button and pull the seat out of the frame.
6-3 - Installation of seat in motion direction.
6-4 - Installation of seat in parent facing mode.
6-3, 6-4, 6-5, 6-6, 6-7, 6-8, 6-9, 6-10 – BACKREST AND SEAT ADJUSTMENT
Note:Usethexingforadditionalstabilityofrequiredposition.(6-6).Fixthebottomofseattothesupport-
ingframe(6-7).Atthebackofthebackrestislocatedthemechanismforrecline(notshowninthegure).
Pressmechanismwithtwongersandmoveitupwardsordownwards.Releasethemechanismtoxthe
backrestinrequiredposition.
7 – PARKING DEVICES
ATTENTION! Apply the parking devices always when stroller is not in motion to avoid risk of stroller sliding.
8 – CANOPY ADJUSTMENT AND CUP HOLDER INSTALLATION
9 – RESTRAINT SYSTEM (5-POINT SAFETY HARNESSES)
Adjusttheshoulderbeltsandwaistbeltsusingtheadjusterbuckles.
Note:Theharnessmusttwellthebabyandmustnotbetwisted.
IMPORTANT!Regularlycheckifsafetyharnessesarexedtostrollerandwellfastened!Safetyharness-
es must not be worn out or torn and buckles must be strong, without any damages and provide secure
connection.
10 - HANDLE HEIGHT ADJUSTMENT (3 positions)
Note: Fixing is accompanied with click sound.
11- FOLDING OF STROLLER
CAUTION! Always before folding the stroller, set the seat in motion direction, set the backrest in upright
position, fold the canopy and empty the storage basket.
ATTENTION!Lockthestrollerinfoldedpositionusingthexing(11-5)!
12 – COVERT FROM SEAT TO CARRY COT AND FROM CARRY COT TO SEAT
ATTENTION! When the seat is converted into carry cot, it must always be in a face to face mode.
ATTENTION! When the seat is converted into carry cot, always unlock shoulder and waist harnesses from
thestroller,adjustandcoverthemwithmattressthatisnotthickerthan20mm.
13 – INSTALLATION OF CAR SEAT “HAVANA” ON FRAME OF STROLLER
Note: For your comfort, before install the car seat on stroller’s frame, apply the parking devices.
13-1 - Installation
On the frame of this stroller, you can install car seat “HAVANA” through the adaptors. Install the adaptors
to the car seat and then the car seat to the frame of stroller.
ATTENTION! Always install the car seat in face to face mode.
13-2 – Removal of car seat and adaptors
ATTENTION! Always remove the adaptors from the stroller before folding!
ASSEMBLY
FUNCTIONS