Real Fyre Valley Oak Log G8 Owner's manual

Type
Owner's manual

This manual is also suitable for

Real Fyre Valley Oak Log G8

With your new Real Fyre Valley Oak Log G8, you can enjoy the beauty and warmth of a real fire without the hassle of wood or ashes. This gas log set is designed to be used with a Peterson G8E burner and is easy to install and maintain. The logs are made from high-quality ceramic and are hand-painted to look like real wood. They are also durable and will last for many years to come.

The Real Fyre Valley Oak Log G8 is a great way to add ambiance and warmth to your home. It is perfect for use in fireplaces, stoves, and inserts. You can also use it to create a cozy outdoor fire pit.

Real Fyre Valley Oak Log G8

With your new Real Fyre Valley Oak Log G8, you can enjoy the beauty and warmth of a real fire without the hassle of wood or ashes. This gas log set is designed to be used with a Peterson G8E burner and is easy to install and maintain. The logs are made from high-quality ceramic and are hand-painted to look like real wood. They are also durable and will last for many years to come.

The Real Fyre Valley Oak Log G8 is a great way to add ambiance and warmth to your home. It is perfect for use in fireplaces, stoves, and inserts. You can also use it to create a cozy outdoor fire pit.

1
CAUTION...............WARNING...............IMPORTANT
USE ONLY A PETERSON REAL FYRE G8E BURNER WITH THIS REAL FYRE LOG SET.
Important: Adequate spacing between the
logs is NECESSARY and MUST be
maintained. If carbon build up (sooting)
exists, correct log placement before
sooting becomes worse. If any sooting
occurs outside of the fi rebox (i.e. on
the walls), turn off unit immediately
and contact a qualifi ed professional
service technician.
WARNING: Use ONLY a Peterson Real Fyre
G8E burner with this Real Fyre gas log
set. Failure to do so may result in
property damage or personal injury,
and will void listings, certifi cations,
and invalidate claims made to RHP.
Contact your local Real Fyre dealer if you
need more information.
This instruction contains log set placement for these Real Fyre logs. You must position and maintain the log
layout as shown here to ensure proper operation of the burner system. Incorrect log installation could cause
ame impingement and improper combustion, resulting in soot and/or excessive by-products of combustion.
DO NOT add any additional embers for this installation. Any additional embers will cause unsafe operation.
Use these logs only with a Peterson G8E burner system.
If you experience an accumulation of black carbon (soot) on your logs it is an indication of incomplete
combustion and you must correct the log placement as instructed in this manual. If signifi cant sooting
continues, stop using this gas log set.
Please read these instructions completely and carefully.
This product is only warranted when used as part of a
Robert H. Peterson Co. unvented burner system.
ROBERT H. PETERSON CO. • 14724 East Proctor Avenue • City of Industry, CA 91746
LOG SET IMPORTANT INFORMATION
L-F2-130REV 0 - 1904081335
VALLEY OAK LOG PLACEMENT INSTRUCTIONS
VO8E-20 shown
2
Failure to use a Peterson G8E burner may result in a DANGEROUS
situation and in property damage, personal injury or even death, will void
listings and certifi cations, and will void any insurance coverage by R.H.
Peterson Co. or our insurers.
CAUTION: Burn hazard! Logs will remain hot for some time after use.
If you need to reposition any log to maintain the proper layout,
use heat resistant gloves or allow logs adequate time to cool
before handling.
WARNING: This gas log set is for use with an R.H. Peterson Co. G8E
burner (and parts) ONLY.
L-F2-130REV 0 - 1904081335
3
VALLEY OAK LOG PLACEMENT INSTRUCTIONS (16", 20", & 24" MODELS)
III
I
II
VO8E-(16,20,24)
PARTS LIST
All items for this log set are included in one (1) box.
CAUTION: Burn hazard! Logs will remain hot
for some time after use.
1
2
VOL8E-12BR
3
VOL8E-8TL
4
5
VOL8E-11TR
VOL8E-10T
The underside of the bottom logs have cutouts and notches that align over the burner. THE BOTTOM LOGS
MUST BE FULLY SEATED ON THE BURNER. Certain logs have notches on them to allow for the logs to
interlock in place.
VOL8E-7TC
6
VOL8E-8TY
7
Place the rear log (log #1) on the back of the ODS mounting
bracket so that the ODS cover fi ts into the cut-out on the
bottom of the log. Slide the rear log forward until it sets into
position. ENSURE THE LOG RESTS FLAT ON THE BURNER.
Center the front log (log #2) on the grate. The log has a small
bottom-rear notch that aligns onto a tab on the left of the grate
for proper positioning. ENSURE THE LOG RESTS FLAT ON
THE BURNER/GRATE.
Place the left middle log (log #3) as shown. The log should
lock in place over the logs below.
Place the right middle log (log #4) as shown. The log should
lock in place over the logs below.
III
position.
ENSURE THE LOG RESTS FLAT ON THE BURNER
Pl
ac
e
th
e
left middle lo
(log #3) as shown. The log shou
ld
lock in
pl
ace over the l
og
s belo
w.
1
II
Center the
front log
g
(log #2) on the grate. The log has a small
bottom-rear notch that aligns onto a tab on the left of the grate
2
3
4
16" - VOL8E-16BF
20" - VOL8E-20BF
24" - VOL8E-24BF
VO8E-20 log set shown
4
VALLEY OAK LOG PLACEMENT INSTRUCTIONS (16", 20", & 24" MODELS)
(CONT.)
IV
V
After setting the logs into position as described above, ensure each is properly and fi rmly seated. The
vent-free gas log set will not function as intended if the logs are not correctly positioned. When placed
properly, the fl ames will not strike any portion of the logs. Periodically check the positioning of all logs to
ensure proper log placement and stability. If any fl ame is striking the logs, recheck log placement. Adjust
to conform with instructions. There should be no fl ame impingement on the logs.
Place the left top log (log #5) as shown. The log should
lock in place over the logs below.
Place the right top log (log #6) as shown. The log should
lock in place over the logs below.
Place the center top log (log #7) as shown. The log should
lock in place over the logs below.
I
V
Place the
left t
op
l
og
pg
(
lo
g
#5
)
as shown. The lo
g
should
lock in place over the logs below.
V
Place the
center t
op
l
og
pg
(
lo
g
#7
)
as shown. The lo
g
should
lock in
pl
ace over the l
og
s below.
7
5
6
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4

Real Fyre Valley Oak Log G8 Owner's manual

Type
Owner's manual
This manual is also suitable for

Real Fyre Valley Oak Log G8

With your new Real Fyre Valley Oak Log G8, you can enjoy the beauty and warmth of a real fire without the hassle of wood or ashes. This gas log set is designed to be used with a Peterson G8E burner and is easy to install and maintain. The logs are made from high-quality ceramic and are hand-painted to look like real wood. They are also durable and will last for many years to come.

The Real Fyre Valley Oak Log G8 is a great way to add ambiance and warmth to your home. It is perfect for use in fireplaces, stoves, and inserts. You can also use it to create a cozy outdoor fire pit.

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI