5.8
WIRELE S S
S U B W O O F E R
A C C E S S O R Y
USERS GUI DE
• (1) WSA RX Receiver
® ®
• (1) WSA TX Transmitter
• (1) 6.0V DC Adapter
• (1) Mounting Bracket
NERO WSA
NERO WSA utilizes
USERS GUIDE
Each WSA TX & WSA RX comes with an included bracket
for mounting to a subwoofer, flat surface or other
applicacations. Follow these steps to install a receiver to
the back of a subwoofer.
WSA RX bracket
Attach the WSA RX to the bracket with a firm press. The
unit will snap into place. Use an RCA cable and the
provided power cable to complete the install.
USERS GUIDE
USERS GUI DE
For Pairing With The WSA TX:
1. On the WSA RX receiver, connect the Sub Out output to the LFE/Mono input on the sub
amplifier.
2. On the WSA TX transmitter, connect an audio source to the Audio In RCA jack. For LFE/mono
signals use the L channel of the RCA jack.
3. Plug in the power supplies to the wall outlet, but wait to apply power.
4. On the WSA RX receiver, power the device by applying the 6.0V DC in.
5. Press the Pair button on the WSA RX.
6. Within 10 seconds of pressing Pair on the receiver, power on the WSA TX transmitter by
applying the 6.0V DC in. Note: During the boot up process the WSA TX searches for the WSA RX
in Pair mode and connects automatically.
7. The LED indicator light will flash while not connected. Once the LED stops flashing and turns
solid then the connection is complete.
8. If the Pairing fails, refer to the troubleshooting steps of this guide.
USERS GUIDE
USERS GUIDE
NERO WSA man. 12/18
WARRANTY
All OSD AUDIO electronics have (2) year Limited Warranty against defects in materials and workmanship. Proof of
purchase must accompany all claims. During the warranty period OSD AUDIO will replace any defective part and correct
any defect in workmanship without charge for either parts or labor.
OSD AUDIO may replace returned electronics with a product of equal value and performance. In such cases, some
modifications to the mounting may be necessary and are not OSD AUDIO’s responsibility.
Damage to or destruction of components due to application of excessive power voids the warranty on those parts. In these
cases, repairs will be made on the basis of the retail value of the parts and labor. To return for repairs, you must email
customer service at [email protected] for a Returned Merchandise Authorization (RMA) number then the unit
must be shipped to OSD AUDIO at the owner’s expense, along with a note explaining the nature of service required. Be
sure to pack the product(s) in a corrugated container with at least 3 inches of resilient material to protect the unit from
damage in transit.
This Warranty Does Not Cover: Damage caused by abuse, accident, misuse, negligence, or improper operation (installa-
tion). Any products that have been altered or modified. Any product whose identifying number of decal, serial #, etc. has
been altered, defaced or removed. Normal wear and maintenance.
osduadio.com
/