CAUTION: TO REDUCE THE RISK OF ELECTRIC
SHOCK, DO NOT REMOVE COVER (OR BACK) NO
USER SERVICEABLE PARTS INSIDE. REFER SER-
VICING TO QUALIFIED SERVICE PERSONNEL.
The important note is h)cated on the rear of the cal)inet.
WARNING: APPLI-
TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS
ANCE TO RAIN OR MOISTURE.
CAUTION Ak THIS SYMBOL INDICATES THAT DAN-
GEROUS VOLTAGE CONST[-TUT[NG A
RISK OF ELECTRIC SHOCK IS PRE-
SENT WITHIN THIS UNIT.
THIS SYMBOL INDICATES THAT
THERE ARE IMPORTANT OPERATING
AND MAINTENANCE INSTRUCTIONS
IN THE LITERATURE ACCOMPANY-ING
THE APPLIANCE.
IMPORTANT SAFEGUARDS
1. Read instructions-All tile salety and operating inslruc-
lions should be iead belore the appliance is operated.
2. Retain Instructions-Tile salety and operaling inshtlc-
lions should be retained lot fltture relerence.
3. Heed Warnings-All warnings on the appliance and in
the opeiating instructions should be adhered to.
4. Follow Instructions-All opeiating and use instluctions
sllould be kdlowed.
5. Cleaning-tJnplug TV fl+om the wall Driller belore clean-
ing. Do not use liquid cleaneis oi aerosol cleaners. Use
a damp cloth Ior cleaning.
EXCEPTION: A product that is meallI lot uninterrtlpl-
ed service and. that loi some specific reason, slich as
file possibilily (If the loss (if an aulhoiization code loi a
CATV conveitel; is nol intended 1o be unplugged by
the usei lot cleaning or ally olller purpose, may
exclude lhe relerence 1o unplugging the appliance in
tile cleaning descriplion otherwise iequired in ilem 5.
6. altachmenls-Do nol use attachments not recomlllended
by the TV manuhlcmier as lbey may cause Imzards.
7. Water and Moislure-Do not Ilse lhis TV neai waleL RII
example, neai a bath lub. wasll bowl. kilcben sink. oi
lallndry ltlb. in a wet baselDelll, or near a SWilDming
pool. and file like.
8. Accessoiies-Do not place Ibis TV on an unstable cart,
sland, tiipod, biacket, oi table. The TV nlay lall, caus-
ing serious illiuiy 1o sonleolle, and seriotis damage 1o
tile appliance. Use only with a call. stand, lripod,
bracket, or table ieconlmended by Ihe nlanLllaCtllier, oI
soM wilh file TV.
Ally mounting of file appliance shoukl follow file man-
liI+lcI/Irer_s illslrlictiolIS alld shollkl PORTABLeGARTWARNING
lise a lnolinling accessory recolD-
mended by file nmnulactuier. An
appliance and carl combination
sllould be nloved wilh cam. Quick
stops, excessive force, and uneven
suililces may cause die appliance
and cart combination to overRlin.
AMEUBLES- Cet appareil lie doit Sy_48OLEDt,VERTISSEMENTpOU_LESOOMPOSANTES
APPAREILErMEUBLEAROULETTES
{Ttre placd que sui till meuble
(avec Oil sans iotllettes) recolll-
inand4 par le Iabiicant. Si vous
Pinstallez stir un meuble ,L
roulettes, d@lacez les deux
ensembles avec pr&aution. Un
aii+t biusque, l'utilisation d'une Iorce excessive et des
sudaces ii'i_Sguli_res risquent de d_Sstabiliser l'ensemble
el de le ienvePsei+
9. Velltilation-Slots and openings in the cabinet and the
back oi bottom are provided loi ventilation and to
ensure reliable opeiation of the TV and to protect it
B+om oveiheating, these openings nmst not be blocked
or coveied. The openings sboukl [lever be blocked by
placing the TV on a bed, sol+t, rug, oi other similar sur-
lace. This "IV should never be placed neai or over a
radiatol or heat iegistei. This TV should not be placed
in a built-in installation stich as a bookcase oi rack
unless propei ventilation is provided or the manulac-
turer's instructions have been adllered to.
10. Power Sources-This TV should be opeiated only h+om
the type of powei souice indicated on file maiking
label. If you lie not sum of the type of power supply to
your home, consult youi appliance dealer or local
powei company. For TVs intended to opeiate Born bat-
tery powei, or other sources, icier to tile operating
illStI fictions+
11. Grounding or Polarization-Tills TV is equipped wilh a
polarized alternaling-current lille plug(a plug having
one blade wkler lhan lhe olher). This plug will fit inlo
file powei outlel only one way. This is a safety leatuie.
If you aie unable to insert tile plug Billy into tile outlet.
tIy reversing the plug. ff the phig should still lail to fit,
contact youi eleclrician 1o replace youi obsolele oullel.
Ek_ not deleal lhe salely purpose of file polaiized plug.
12. Power-Coid Proteclion-Power-supply coids shouM be
fouled so tllal riley are not likely to be walked on oi
FIGURE A --- _-<_---- ___.
EXAMPLE OF ANTENNA GROUNDING AS PER
NATIONAL ELECTRICAL CODE .-- ANTENNA
""J_ LEAD iN
........ WIRE
ELECTRIC
SERVICE
EQUIPMENT_.____. GROUNDINGCONDUCTORS
EC SECTION810-21)
_ GROUNDCLAMPS
NEC NATIONAL ELECTRICALCODE _. POWERSERVICEGROUNDING
ELECTRODESYSTEM
$2898A (NEDART250 PARTN}
pinched by items placed upon or against lhem, paying
particulai attention to cords at plugs, convenience
receptacles, and file poinl wllere riley exil fl'oln the
appliance.
13. Outdooi Anlenna grounding-If an oulside antenna oi
cable system is connecled 1o the TV, be sum the anten-
na or cable systelD is grounded so as 1o provide some
prolection against voltage suiges and buill-up static
charges. Alticle 810 of lhe Nalional Electrical Code,
ANSI/NFPA No. 70, provkles inlormatkm with iespecl
1o proper grounding of lhe mast and suppoiting stiuc-
luie, giounding of file lead-in wiie to an antenna dis-
charge unit. size of giounding conductors, location of
antenna-discharge unit. conneclion 1o groundfllg elec-
hodes, alld reqtlirenlenls lot file grolllding eleclrode.
(Fig. A)
14. Lighming-Foi added plolection for this TV receiver
during a ligbming StOlm, oi when it is lelt unaMended
and unused for long periods of lime, unplug il fiOlll the
wall oullel and disconnect the anlenna or cable system.
This will plevenl danmge 1o lbe TV due to lighming
and power-line sulges.
15. Power Lines-An outside antenna system shoukl nol be
located ill lbe vicinity of overhead power lines oi olher
electric lighl of powei circuits, or where il can hall into
such power lines or circuils. When installing an outside
anlenna syslenl, extreme (ale should be taken 1o keep
lrom loucbing such power lines oi circuits as contact
wilh them might be fim_l.
16. Ovelkmding-Do nol ovelload wall oullels and exten-
sion cords as ll/is call result ill a risk of fire oi elech'ic
shock.
17. Object and Liqukl Entry-Never push objects of any
killd into Ibis TV through openings as they may totlch
dallgerous voltage points oi short out palls tllal could
result in a fire oi elecnic sllock. Nevei spill liquid of
any kind on file TV.
I8. Seivicing-Do not attempl to seiwice this TV yourself as
opening oi relDoving covers may expose yol110 dan-
geious voltage or ofllei Ilazards. Relei all servicing 1o
qualified service personneh
19. Damage Requiring Sep, ice-Unl)hlg lllis "IV flonl tile
wall omlet and icier servicing to qualified selwice pei-
sonnel under lhe lollowing ColldiliOllS:
a. When file power supply coid oi plug is damaged oi
fl'ayed.
b. If liquid has been spilled, or obiects have lidlen into
lhe TV.
c. If file TV has been exposed to iain oi walel:
d. If file TV does nol opeiale normally by lollowing lhe
opeiating instructklns. Adjust only lllose controls that
lie covered by file operating instructions, as improper
adjlstlnellt of olher conhols may result in damage and
will often requiie extensive woik by a qualified lechni-
cian to iestore lhe TV 1o ils noliDa] operation.
e. If lbe TV has been diopped oi danmged ill any way.
L When the TV exlfibits a distinct change in pellor-
mance-d/is indicates a need ku selwice.
20. Replacemenl Palls-When replacenlent parts lie
required, be slim lhe service leclnlician uses replace-
ment paits specified by lhe manuhtcmrei lbal have lbe
same clmiacterislics as file original pail. IJnaulhoiized
slbslittllions iDayresult ill fire. elechic sllock, iltiuiy to
peisons oI other Ilazards.
21. Salety Check-Upon completion of ally seivice OI
repaiis to lllis TV. ask file seivice technician to peilorn/
rouline salely (becks to determine tllal file TV is in
proper operating condflion.
22. Heat-This TV pioduct sllould be situated away fl'om
heat sources such as radiators, heal registers, stoves, oI
olller pioducts (inchlding amplifiers) tllal pioduce Ileal.
This manual covers 13" and 19". The operation of the two models are exactly the same except the appearance. 19" model is illustrated in this manual. ]
OPERATING CONTROLS AND FUNCTIONS
- FRONT PANEL -
1 2
- REMOTE CONTROL -
3 4 6 7 85
I. VIDEO (in) jack- Connect to the video
output ,jack of a video camera or VCR.
2. AUDIO (in) jack- Connect to the audio
output .jack ol a video camera or VCR.
3. EARPHONE jack- To connect earphone
(not supplied) lOl"personal listening.
NOTE: Do not connect earphones that have
an L-shaped plug. The plug may iutel'tere
with the cabinet.
4. MENU button- Press to display the menu
on the TV screen.
5. VOLUME A/'IF buttons- Press to control
the volume level.
Press to determine a setting mode fl'om the
melm on the TV screen. (only the VOL i,
button)
Press to select or adjust fl'oma particular
menu. (tbl"example: Language Selection,
Channel Presetting, Closed Caption Selection,
PictureAdjustnlent, V-CHIP Set Up)
6. CHANNEL A/V buttons- Press to select
melnorized chaunel.
NOTE:You MUST PRESET channels
BEFORE using CHANNEL A/Y button.
(See CHANNEL PRESETTING)
Press to select a setting mode fl'oln the
meuu on the TV screen.
Press to select item you want to adjust in
the picture control lnode.
7. POWER button- Press to turn the TV ON
and OFE
- REAR PANEL -
Iit s !
8. Infrared Sensor Window- Receives the
inti"ared control signals froln the relnote
control unit.
9. CHANNEL NUMBER buttons- Press two
digits to directly access the desired channel.
Remelnber to press a "0" before a single
digit channel.
+100 button- Press to select cable channels
which are equal or greater than number 100.
10.MUTE button- Press the MUTE button to
turn ot_ the sound portion of the TV pro-
gram. (Volume level display turns LIGHT
RED twin LIGHT BLUE.) Press the
MUTE button again or press the VOL(ume)
Ak or 'IVbutton to restore sound.
1I.CHANNEL RETERN button- Press this
button to go back to the previously viewed
channel. For example, pressing the CHAN-
NEL RETURN button once will change
channel display h'om CH 3 (present chan-
nel) to CH 10 (previously viewed chalmel),
and pressing it second tilne will returu from
CH 10toCH3.
12.DISPLAY button- Press to display the
channel number on the screen. If you press
it again, the channel nulnber will disappear.
13.SLEEP button- Press the SLEEP button to
display the sleep tinier and start the lunc-
tion. The shut ot_ time can be determined
by the nulnber of times you press the but-
ton. (0, 10, 20, 30,..90, 0 lninutes)
14.GAME button- Press to set the Galne
mode and external input mode at the salne
time. Press the GAME button again to exit
the lnode.
15.ANT(enna). IN jack- Connect to an anten-
na, cable systeln, or satellite systeln.
16.AC cord- Connect to a standard AC outlet
(120V/60Hz).
NOTE: Remove the AC cord h'om the
hook to avoid breaking a wire belore you
connect to a standard AC outlet.
[_ Slide tbe battery compartment cover on
tbe remote unit.
[_ Iusert 2 "AA" peulight batteries into bat-
tery compamnent in the directiou as indicated
by the polarity (+ / -) markings. Batteries
installed with incorrect polarity *nay damage
IIt.!11 II ltillll I Ilill lU I Ill Ill I] II
When cisingan external input signal (VCR or
cam(order), connect the player's audio/video
output cables to the AUDIO IN/VIDEO IN
,jacks of your TV. Tben press the GAME button.
For details, see "USING THE GAME BUT-
TON" in PICTURE ADJUSTMENT section.