Sharper Image Steam Instant Heat Curlers Owner's manual

  • Hello! I am an AI chatbot trained to assist you with the Sharper Image Steam Instant Heat Curlers Owner's manual. I’ve already reviewed the document and can help you find the information you need or explain it in simple terms. Just ask your questions, and providing more details will help me assist you more effectively!
CAUTION: Never allow power supply cord to be
pulled, twisted or severely bent. Never wrap the
cord tightly around the unit. Damage will occur at
the high flex point of entry into the unit, causing
it to rupture and short circuit. Inspect the cord
frequently for damage. Stop use immediately
if damage is visible or unit stops or operates
intermittently. If cord or unit is damaged or does
not operate properly, return it for repair to an
authorized Conair Service Representative only. No
repairs should be attempted by the consumer.
Rollers and Foams:
Pull rollers apart to clean, gently pushing back
the foam to pull off the endcap. Slide foam off
the core and clean in warm water with mild
detergent. Rinse thoroughly, blot excess water
and allow to dry completely before putting back
on rollers to reuse.
IMPORTANT: After using the hairsetter several
times, you will find the best timing for the length
and texture of your hair and for the result you
desire.
Styling Tips
For maximum results, use one or two rollers on
the top front layer of your hair. Use the remaining
rollers on the sides and back of the head. The
hair should be taken in equal sections and rolled
under, toward your neck. After approximately 10
minutes or when rollers have cooled the rollers
can be removed. Let hair cool for one minute and
then style.
OPERATING
INSTRUCTIONS
For use in the U.S.A., the voltage selector
switch should be placed in the 120V position.
For use in several countries overseas, the
voltage selector may need to be placed in the
240V position. Confirm the voltage available
at each overseas location before using the
appliance. For connection to a 240 volt supply,
use an attachment plug adapter of the proper
configuration for the power supply receptacle.
Adjust your setter to the higher voltage by
changing the switch position located on the
back of unit.
Prepare for use
1. Make sure unit is unplugged
and remove steamer top from
reservoir before filling.
2. Fill about half-way (to water level
line with water) replace top with
rollers and plug in.
3. After about 90 seconds, when
unit begins to steam the rollers
are ready to use.
4. Roll hair around steam-infused
roller.
REPLACEMENT PARTS
Model Description Price
RP67 3-¾-inch Roller $3.99
and shields
Please add postage and handling to all orders.
Postage and handling are as follows: Any order
up to $10.00 – add $1.00 to order. Any order
from $10.01 and over – add $1.50 to order.
Name: _______________________________________
Address: _____________________________________
City: _______________State: __________ ZIP: ______
Daytime Phone: (____) ___________________________
Note: Prices subject to change without notice. When
ordering outside continental U.S.A., consumer must
include cost for airmail and parcel post. Allow 4 to 6
weeks for delivery. Outside U.S.A., payments must be
drawn on U.S. banks, in U.S. dollars only.
Please mail to:
Conair Corporation
7475 N. Glen Harbor Road
Glendale, AZ 85307
GENTLE CURLS STEAM ROLLERS
12 ¾-INCH ROLLERS
AND ROLLER SHIELDS
IMPORTANT SAFETY
INSTRUCTIONS
When using electrical appliances, especially when
children are present, basic safety precautions
should always be taken, including the following:
READ ALL INSTRUCTIONS
BEFORE USING
KEEP AWAY FROM WATER
DANGER – To reduce the risk of
electrocution:
1. Always unplug this appliance
immediately after using.
2. Do not use while bathing or in the shower.
3. Do not place or store appliance where it can
fall or be pulled into a tub or sink.
4. Do not place in or drop into water or
other liquids.
5. Do not reach for an appliance that has
fallen into water. Unplug immediately.
WARNING –
To reduce the risk of
burns,
electrocution, fire, or injury to persons:
1. An appliance should never be left
unattended when plugged in.
2. This appliance should not be used by,
on, or near children or individuals with
certain disabilities.
3. Use this appliance only for its intended use
as described in this manual. Do not use
attachments not recommended by Conair.
4. Never operate this appliance if it has a
damaged cord or plug, if it is not working
properly, if it has been dropped or
damaged, or dropped into water. Return
the appliance to an authorized service
center for examination and repair.
5. Keep the cord away from heated surfaces.
6. Never block the air openings of the
appliance or place it on a soft surface, such
as a bed or couch, where the air openings
may be blocked. Keep the air openings free
of lint, hair, and other debris.
7. Never use while sleeping.
8. Never drop or insert any object into any
opening or hose.
9. Do not use outdoors or operate where
aerosol (spray) products are being used or
where oxygen is being administered.
10. Do not touch the bars that hold the rollers.
They are hot.
11. Use hairsetter on a level surface.
12. The cord can be wrapped around the stand
for storage. Do not wrap the cord around any
other parts of the appliance.
13. Do not use with a voltage converter.
14. Do not use with an extension cord.
15. This appliance is not a toy. Keep away from
children.
16. Before plugging in the unit, read information
on DUAL VOLTAGE found under OPERATING
INSTRUCTIONS.
SAVE THESE
INSTRUCTIONS
Create curls
1. Place section of hair evenly
on the roller and roll upwards
towards scalp. Snap roller shield
into place.
2. To create a tighter, bouncy
curl, roll or wrap but apply extra
pressure while rotating up.
3. To wrap hair around the roller,
place the roller mid-section of
hair strand and roll either under
or over to the scalp. Snap roller
shield into place.
Unroll and style
1. To remove rollers, gently take
off shield clip. Rotate the roller
downwards in a dropping motion
without pulling or tugging.
2. If desired, separate curls with
fingers to loosen. Do not comb
or brush. For extra volume, flip
hair over and loosen at the root.
Cleaning and storage
Empty water reservoir when not in use. Unplug
unit and allow it to cool. Turn unit upside down
and drain. Dry the exterior with a cloth. Wrap
the power cord up and store in a dry place.
Clean the unit occasionally to remove mineral
buildup. Using distilled or purified water helps
lessen this build up, but in general, you should
clean your hair setter after every 20 uses, more
often if the water in your area is hard.
12 ¾-inch diameter
bare roller
12 ¾-inch diameter
roller shields
Foam
Shield
MAINTENANCE
Your hairsetter is designed for household
use and is virtually maintenance free. This
product represents the highest standards of
workmanship and engineering research.
If cleaning becomes necessary, disconnect the
appliance from the power source. Allow the
hairsetter to cool. Clean the unit and the metal
rails with a damp cloth. (Occasionally you may
want to clean the rollers. Use a damp cloth
and mild detergent or soap.) If any abnormal
condition occurs, unplug the hairsetter, allow it
to cool, and return it to an authorized service
representative for repair.
STORAGE
Allow hairsetter to cool. Handle cord carefully
for longer life; avoid jerking or straining at plug
connections. Place hairsetter out of reach of
children in a safe, dry location.
Do not wrap line cord around unit. Allow the
cord to hang or lie loose and straight at the
point of entry into the unit.
LIMITED THREE-YEAR WARRANTY
(U.S. AND CANADA ONLY)
Conair will repair or replace (at our option) your
unit free of charge for 36 months from the date of
purchase if the appliance is defective in workman-
ship or materials.
To obtain service under this warranty, return the
defective product to the service center listed on back,
together with your purchase receipt and $5.00 for
postage and handling. California residents need
only provide proof of purchase and should call
1-800-3-CONAIR
for shipping instructions. In the
absence of a purchase receipt, the warranty period
shall be 36 months from the date of manufacture.
ANY IMPLIED WARRANTIES, OBLIGATIONS, OR
LIABILITIES, INCLUDING BUT NOT LIMITED TO
THE IMPLIED WARRANTY OF MERCHANTABIL-
ITY AND FITNESS FOR A PARTICULAR PURPOSE
SHALL BE LIMITED IN DURATION TO THE
36-MONTH DURATION OF THIS WRITTEN, LIM-
ITED WARRANTY. Some states do not allow
limitations on how long an implied warranty lasts,
so the above limitations may not apply to you.
IN NO EVENT SHALL CONAIR BE LIABLE FOR
ANY SPECIAL, INCIDENTAL, OR CONSEQUENTIAL
DAMAGES FOR BREACH OF THIS OR ANY OTHER
WARRANTY, EXPRESS OR IMPLIED, WHATSO-
EVER. Some states do not allow the exclusion or
limitation of special, incidental, or consequential
damages, so the above limitation may not apply
to you.
This warranty gives you specific legal rights, and
you may also have other rights, which vary from
state to state.
WARNING:
IF YOU THINK THE
POWER IS OFF WHEN
THE SWITCH IS OFF,
YOU’RE WRONG.
KEEP AWAY FROM WATER
Everyone knows that electricity and water
are a dangerous combination. But did you
know that an electric appliance is still
electrically live even if the switch is off?
If the plug is in, the power is on. So when
you are not using your appliances, keep
them unplugged.
ALWAYS UNPLUG
SMALL APPLIANCES
GETTING TO KNOW
YOUR HAIRSETTER
• 12 ¾-inch Rollers with shields
• Perfect for all hair types
• Steams and conditions as it curls
• Creates long lasting curls and volume
Please register this product at
www.conair.com/registration
Service Center
Conair Corporation
Service Department
7475 N. Glen Harbor Blvd.
Glendale, AZ 85307
stock.image
©2017 Conair Corporation
150 Milford Road, East Windsor, NJ 08520
7475 N. Glen Harbor Blvd., Glendale, AZ 85307
17PH030157
IB-14255
1875 WAT T
STYLING TOOL
INSTRUCTION &
STYLING GUIDE
HS67 MODELS
GENTLE CURLS
STEAM ROLLERS
12 ROLLERS
INCLUDED
/