WiXHC PHB04B-4 Wireless Remote Controller Operating instructions

Hello! I've analyzed the provided instructions for the Wireless remote PHB04B. This document details its connection to a CNC system via USB and phb04b DLL, features like 6 axes and LCD display support, and the use of 433MHz for wireless communication. I am ready to assist you with any questions you may have about this device based on the provided document.
What is the communication method between the remote and the computer?

How does the remote controller transmit data to the CNC system software?

Does the phb04b DLL support other platforms beside windows?

PHB04B-4 Wireless remote instructions

The remote controller is connected to the computer through the USB receiver, and the key

data is transmitted to the USB receiver, which is connected through phb04b DLL transmits keys to

CNC system software; The CNC system transmits the data to be displayed to the USB receiver, and

the receiver returns the data to the remote controller Thus, two-way communication is realized

Currently phb04b DLL only supports windows platform

Phb04b wireless remote control, supporting 13 keys;

6 axes, x, y, Z, a, B, C; 4 magnification: 1X, 10100x, 1000x LCD data display is supported. Users can

freely define the contents of LCD display, with a maximum of 59 ASCII characters With 100ppr

handwheel.

RF adopts 433MHz ism standard frequency band, data encryption transmission, fast

transmission speed, automatic detection of interference and frequency hopping, strong

anti-interference

Users use phb04b The basic process of DLL programming is as follows:

a) Load phb04b DLL and locate functions. The method depends on the specific programming

language.

b) Call xinit function to initialize

c) Call xsendoutput function to transmit data to remote controller

d) Call xgetinput function to receive data

e) Call the xopen function to open the device

f) Call xclose function to shut down the device

FCC WARNING

This device complies with part 15 of the FCC Rules. Operation is subject to the following two

conditions: (1) this device may not cause harmful interference, and (2) this device must

accept any interference received, including interference that may cause undesired

operation.

Any changes or modifications not expressly approved by the party responsible for

compliance

could void the user's authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B

digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a residential installation. This

CNC system

DLL

PHB04B.DLL

PHB04B

Wireless remote

equipment generates, uses and can radiate radio frequency energy and, if not installed and

used in accordance with the instructions, may cause harmful interference to radio

communications. However, there is no guarantee that interference will not occur in a

particular installation.

If this equipment does cause harmful interference to radio or television reception,

which can be determined by turning the equipment off and on, the user is encouraged to try

to correct the interference by one or more of the following measures:

-- Reorient or relocate the receiving antenna.

-- Increase the separation between the equipment and receiver.

-- Connect the equipment into an outlet on a circuit different

from that to which the receiver is connected.

-- Consult the dealer or an experienced radio/TV technician for help.

The device has been evaluated to meet general RF exposure requirement. The device can be

used in portable exposure condition without restriction