Otter Shower Stand Operating instructions

Brand
Otter
Model
Shower Stand
Type
Operating instructions

This manual is also suitable for

Below you will find brief information for OT 8020. The Otter Shower Stand is designed to elevate the Otter Bath Chair for use in the shower. It is made of aluminum and is compatible with all three sizes of the Otter Bath Chair. The stand features casters that can be locked for stability or unlocked for mobility. It is important to inspect the stand regularly for any damage and to wash it with soap and water or a 10% bleach solution. The device is covered by a two-year limited warranty against defects in materials and workmanship.

Below you will find brief information for OT 8020. The Otter Shower Stand is designed to elevate the Otter Bath Chair for use in the shower. It is made of aluminum and is compatible with all three sizes of the Otter Bath Chair. The stand features casters that can be locked for stability or unlocked for mobility. It is important to inspect the stand regularly for any damage and to wash it with soap and water or a 10% bleach solution. The device is covered by a two-year limited warranty against defects in materials and workmanship.

otter shower stand
item # OT 8020
www.drivemedical.com
two year limited
warranty
Your Drive brand product is warranted to be free of
defects in materials and workmanship for two years
from the date of the original consumer purchase.
This device was built to exacting standards and
carefully inspected prior to shipment. This Two
Year Limited Warranty is an expression of our
confidence in the materials and workmanship of
our products and our assurance to the consumer of
dependable service.
In the event of a defect covered by this warranty, we
will, at our option, repair or replace the device.
This warranty does not cover device failure due to
owner misuse or negligence, or normal wear and
tear. The warranty does not extend to non-durable
components such as rubber accessories, casters, and
grips, which are subject to normal wear and need
periodic replacement.
If you have a question about your Drive device or
this warranty, please contact an authorized
Drive dealer.
© 2006 Medical Depot, Inc. All rights reserved.
Drive is a trademark of Medical Depot, Inc.
Port Washington N.Y. 11050 USA Made in China
EU Authorized Representative
Drive International, LLC
Globe Lane - Stockport
DUKINFIELD SK16 4RE, GB
step 1
Insert four plastic end caps (A) into both lever crossbars
(B) and connect crossbars to the two side frames (C)
using screws supplied. Do not tighten screws.
NOTE: All triggers must face toward the center of base.
assembly instructions
step 2
Insert four plastic end caps (A) into leg crossbars (D)
and connect crossbars to the two side frames using
screws supplied.
step 3
Tighten all screws.
The Otter Tub Stand elevates the Otter Bath Chair for
use in the shower. All three Otter Bath Chair sizes fit
on the Shower Stand. It is constructed of aluminum.
recommended use
B
C
E
D
D
B
A
B
maintenance and care
1. Inspect the shower stand periodically for cracks,
breaks, loose or missing parts of malfunctions. If a
product needs service or replacement parts,
contact an authorized Drive dealer.
2. Wash shower stand with soap and water or 10%
bleach.
adjustments
1. To mount Otter Bath chair onto Shower Stand,
position bath chair legs to the highest position and
push down firmly on chair until legs snap into
sockets (E) of shower stand. To remove chair from
Shower Stand, depress red levers and pull legs
upward one at a time.
2. Lock all casters to immobilize and unlock for
mobility.
CAUTION:
Adult supervision is required at all times.
  • Page 1 1
  • Page 2 2

Otter Shower Stand Operating instructions

Brand
Otter
Model
Shower Stand
Type
Operating instructions
This manual is also suitable for

Below you will find brief information for OT 8020. The Otter Shower Stand is designed to elevate the Otter Bath Chair for use in the shower. It is made of aluminum and is compatible with all three sizes of the Otter Bath Chair. The stand features casters that can be locked for stability or unlocked for mobility. It is important to inspect the stand regularly for any damage and to wash it with soap and water or a 10% bleach solution. The device is covered by a two-year limited warranty against defects in materials and workmanship.

Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents