2. Concept2
  3. Foot Belly Reinforcement Kit

Concept2 Foot Belly Reinforcement Kit Operating instructions

  • Hello! I've reviewed the instructions for the Foot Belly Reinforcement Kit. This document provides a step-by-step guide on how to install the reinforcement kit, including removing the cover, a metal plate, installing a triangular brace, and re-installing the cover using new fasteners. I'm ready to assist you with any questions you may have about the installation process.
  • What tools are needed for this installation?
    What is the first step in the procedure?
    What is done with the old fasteners?
    What is removed after the cover?
    What is installed next after removing metal plate?
    When should the foot belly cover assembly be reinstalled?
CONCEPT2.COM
Page 1 0815
FOOT BELLY REINFORCEMENT KIT INSTRUCTIONS
Materials Needed
• Phillipsheadscrewdriver
• 7/16”(11mm)oradjustablewrench
Procedure Overview
• Removethefootbellycoverassembly
• Removetherectangularmetalplate
• Installtriangularbracewithnewfasteners
• Re-installfootbellycoverassembly
A
1. UsingaPhillipsheadscrewdriver,removethe
sevenfastenersthatholdthefootbellycover
assemblyinplace.Discardthesefasteners.
Removethefootbellycoverassemblyandset
aside.Itwillbereinstalledinstep4.
 SeeillustrationA.
2. Usinga7/16”wrench,removethehexscrewand
washerthatholdstheverticalrectangularmetal
plateinplaceonthefootbelly.Discardthemetal
plate.SeeillustrationB.
3. Installthetriangularbraceasshownandreinstall
thehexscrewandwasher.Tightenfully.
 SeeillustrationC.
4. Reinstallthefootbellycoverassemblywiththe
sevennew½”fasteners.SeeillustrationD.
5. Repeatfortheotherside.
B
C
Procedure
D
/