ALGE-Timing D-Line User guide

Hello! I've reviewed the user guide for the D-LINE Exchange Processor. This document outlines the procedures for safely removing and reassembling the processor, including the necessary tools and preparation steps. I'm ready to answer your questions about the document or the device itself.
What tools are needed for the processor replacement?

What is the first step in opening the device?

How should the processor pins be prepared before socketing?

tools you need

Allen key

number 3

screwdriver

slot head screwdriver needle-nosed pliers

tool n. 1 tool n. 2 tool n. 4tool n. 3

open the D-SF3

with tool n. 1 unscrew

the cover bolt

extraction

Pull the plexiglass so far, that the first digit is free too see.

with tool n. 2

Remove the 4 screws with tool n. 2

Lift the processor on the left side, with tool n. 3.

But only for 1cm. The pins must

lifted out of the socket, only on the left side. For the right side see the next picture.

For the right side use tool n. 4 and lift the processor out of the

socket

Prepare the processor before you give them into the socket

For this give the processor parallel to an plane ground.

Now bend the pins parallel too the ground so that the

distance are less then before. You must make this until then

the processor falls into place of the socket.

Push the processor, with the indentation for the first pin on the right side,

into the socket. When you have made the last step correct, you can push

the processor with bouth hands planar into the socket

To reassemble goes the steps

back.

Best regards

Reinhard Jochum

25. Okt. 2012

For good success

/

Other documents