Addvent AVAC9000W Installation Instructions And User Manual

Brand: Addvent

Model: AVAC9000W

Category: Mobile air conditioners

Type: Installation Instructions And User Manual

Addvent AVAC9000W is a portable air conditioner with a 24-hour timer, allowing you to set it to turn on or off automatically. It has three fan speeds (high, medium, and low) and three modes (cool, dehumidify, and fan only). The cooling mode cools the air and exhausts hot air outside through the exhaust tube, while the dehumidify mode removes moisture from the air without cooling it. The fan mode simply circulates the air without cooling or dehumidifying it. The AVAC9000W has a built-in air filter that helps to remove dust and other particles from the air.

AVAC9000W

Portable Air Conditioner

with 24 hour timer

Installation Instructions and User Guide

IMPORTANT SAFEGUARDS

WHEN USING ANY ELECTRICAL APPLIANCE, BASIC SAFETY

PRECAUTIONS SHOULD ALWAYS BE FOLLOWED.

PLEASE READ ALL INSTRUCTIONS CAREFULLY

AND RETAIN FOR FUTURE REFERENCE

AVAC9000W[15]instructions 9/4/15 09:43 Page 1

Safety Instructions



Never use this appliance for anything other than its intended purpose.

Your air conditioner is designed to be used in a house, office and similar

conditions and should not be used for any other purpose.



If the supply cord is damaged, it must be replaced by the manufacturer, its

service agent or similarly qualified persons in order to avoid a hazard.



Always keep the unit in an upright position to avoid damage to the cooling

system.



Be sure that the air inlets and outlets are not blocked or covered.



Don t put any object into the air inlet or outlet of the unit.



In order to avoid overheating, do not cover the unit while it is plugged in or

in-use.



Never connect the unit to a defective socket.



Never locate the appliance immediately below a socket-outlet.



Never unplug the air conditioner while it is operating.

This could damage the electronic circuits.



Leave at least 300mm space around the unit.



To avoid tripping the circuit, do not use an extension cord for this unit.



To turn on your unit, insert the plug into the socket and press the power

button.



Do not bend or crush the warm air exhaust hose.



Do not place the power cord under a carpet.



This appliance is for ordinary indoor use. Never use the appliance in the

immediate surroundings of a bath, a shower, a swimming pool or a

greenhouse.



Keep the appliance in the vertical position during transportation. After

unpacking, place the unit upright to allow the refrigerant to stabilise, and wait

3 hours before use.

Any damage resulting from failure to comply with these instructions is

excluded from the warranty. Do not install and use your air conditioner

before completely reading these instructions.

 CAUTION: Dispose of packaging material safely according to local regulations

WARNING

AVAC9000W[15]instructions 9/4/15 09:43 Page 2

Components

1 Control panel

2 Air outlet

3 Carry Handle

4 Caster

5 Air Filter

6 Air outlet (Heat exchange)

7 Air intake (Evaporator)

8 Air intake (Condenser)

9 Water outlet drain for

continuous drain operation

(dehumidify mode only)

10 Water outlet drain note:

please ensure that this is

ﬁrmly ﬁxed before operation

11 Power supply cord

Power supply 220-240V/50Hz

Rated cooling capacity kW 2.64

Rated input W 1000

Energy Efficiency Class (EN14511) EER A

Moisture removal l/h 1.4

Air circulation volume m

/h 280

Temperature Setting Range °C 16-32

Refrigerant/Charge g R410-A

Noise Level dB(A) 53

Body dimension WxHxD mm 420x700x340mm

Net weight kg 25

Warranty: One Year return to base

Speciﬁcations

AVAC9000W

AVAC9000W[15]instructions 9/4/15 09:43 Page 3

Operation

Control Panel

Power Control

The power control turns the unit on and

off.

Warning Light 

Condensed water may accumulate in the

unit. If the internal tank becomes full, the

Warning Light will shine and the unit will

not operate until the unit has been

drained.

Mode Control

The Mode Control has 3 settings:

• Cool • Dehumidify • Fan

The settings are adjusted with Mode

Control button. A light will indicate

which setting is currently being used.

• Cooling Mode

During the cooling mode the air is

cooled and hot air is exhausted to the

outside through the exhaust tube.

Adjust fan speed and air temperature

to suit your desired comfort level.

Note : The air exchange hoses must

vent outside the room when using

cool mode.

• Dehumidify Mode

Air is dehumidified as it passes

through the unit, without being in full

cooling mode. If room temperature is

>25 degree Celsius, fan speed can be

adjusted; otherwise fan speed is fixed

to "low". Note : If the unit is to be

used as a dehumidifier, do not

connect the exhaust hose let the

warm air return to the room.

Continuous drainage is then

necessary.

Fan Mode

Air is circulated throughout the room

with no cooling.

Note: unit does not need to be vented in

Fan mode

Fan Speed Control

The Fan Speed Control has 3 settings:

High, Medium, and Low.

Timer

Auto turn off :With machine in running

mode, press timer button to select

number of hours you would like the unit

to run in air conditioning mode until it

automatically shuts off.

Auto turn on : With machine in stand by

mode, press timer button to select

number of hours until you would like the

unit to automatically start running in air

conditioning mode.

Timer / Temp set controls

• Used for adjusting the timer and

thermostat.

• The default display is room

temperature.

AVAC9000W[15]instructions 9/4/15 09:43 Page 4

Operation

Remote Controller

• In cooling mode, when " + " or " - "

button is pressed, the set

temperature is displayed and may be

adjusted. After 15 seconds the display

will revert back to room

temperature. Temperature is only

adjustable in cool mode. The time is

adjustable between 1~24 hours.

Note : By pressing both " + " / " - " set

buttons at the same time, the display will

toggle between Celsius and Fahrenheit.

Air Conditioner Remote Control (batteries not included)

The functions work the same as your air conditioner's touch controls.

All key function can be accessed from the remote control.

Batteries : Remove the cover on the

back of the remote controller and

insert the batteries with the (+) and

(-) poles pointing in the correct

directions.

CAUTION:

 Use only AAA or IEC R03

1.5V batteries. Remove the batteries if

the remote controller is not used for a

month or longer. Do not attempt to

recharge the supplied batteries All

batteries should be replaced at the same

time. Do not dispose of the batteries in a

ﬁre as they may explode.

After switching the air conditioner off, you must wait 3 minutes before switching it

back on again.

AVAC9000W[15]instructions 9/4/15 09:43 Page 5

Installation

Exhaust Duct Set Assembly and Installation

Connect exhaust hose assembly to the back of the unit. Extend

supplied hose to desired length and locate the exhaust nozzle

through the window for ventilation.

 Insert both ends of the exhaust hose into the two exhaust

nozzle connectors by twisting anti-clockwise until they stop.

 Fix one of the connectors to the rear outlet of the unit.

This is achieved by sliding the nozzle connector downwards

over the exhaust outlet of the unit ensuring that the lugs on

the nozzle connector are engaged with the grooves on the

connector of unit.

 Fix the other exhaust nozzle connector to the exhaust

nozzle.

 Extend the exhaust hose and close the window as much as

possible trapping the exhaust nozzle.

Semi-permanent Installation

If required, your appliance can also be installed

semi-permanently.

 Drill a 125mm hole in an outside wall* or through a

window pane.

 The unit should not be within 300mm of any wall.

 Fit the flange accessory fixture provided in the hole.

 Fit the exhaust hose in the housing at the back of the

appliance.

 Insert the other end of the exhaust hose to the flange

previously fit on the wall as shown.

When the hose is not in use, place the cap for connector to

cover the hole.

NOTE : When installing the air conditioner semi permanently,

you should leave a door slightly open (as little as 1cm) to

guarantee sufficient ventilation.

* Installing through an outside wall: you are recommended to

insulate the section of wall using suitable insulation material.

Exhaust

hose

Exhaust nozzle

connectors (2)

AVAC9000W[15]instructions 9/4/15 09:43 Page 6

Troubleshooting

Problem Cause Solution

The unit does not Power Failure Check Fuse

function

The unit functions for only Improper thermostat Decrease thermostat setting by

brief periods in cooling mode setting adjusting temperature setting

Warning light indicator Internal condensate Drain unit via drain

illuminated tank full plug at rear of unit

Unit functions but Windows open Close windows

does not cool

Another source of heat Remove source of heat

in room or too many

people in room

Thermostat temperature Decrease thermostat setting by

setting too high adjusting temperature setting

Air ﬁlter blocked Clean filter

Air conditioner capacity Consult supplier

is unsuitable for the size

of room or conditions

Loss of refrigerant Call Addvent

Exhaust hose blocked Remove obstruction

The following cases may not always be a malfunction, please check it before

asking for service.

Installation

For continuous/ﬁxed drainage (dehumidify mode)

If you wish to have the unit continuously drain, please

follow the following instructions:

• You will need a 25mm (1 inch) PVC hose

• Remove the cover from the drainage outlet

9 in top figure.

• Remove the soft rubber stopper inside the cover.

• Insert the drain pipe through the ring of the stopper.

• Re-fit into to the drainage outlet.

AVAC9000W[15]instructions 9/4/15 09:43 Page 7

Telephone: 0117 923 5375 Fax: 0117 923 5374

Victoria Road, Avonmouth, Bristol BS11 9DB www.addvent.co.uk

ISSUE 1/0415

Maintenance

Maintenance after using

If unit is dirty use a mild detergent and damp cloth.

1 If the appliance will not be used for a long time, be sure to pull out the rubber drainplug

to allow the water to drain.

2 Before storing away run the unit in fan mode only for few hours to dry any moisture on

the coils to prevent mould.

3 Clean the air filter and reinstall it.

4 Remove the air hoses and store; cover the wall vent with the supplied cap.

Appliance Maintenance

1 Turn off the power supply. Turn off the appliance first before disconnecting from

power supply

2. Wipe with a soft dry cloth. If the unit is dirty use a mild detergent and damp cloth.

3 Never use volatile substances such as petrol or polishing powder to clean the

appliance.

4 Never pour water onto the main unit.

Air Filter Maintenance

It is necessary to clean the air filter after using it for about 100 hours.

Clean it as follows:

1 Stop the appliance and remove the air ﬁlter.

Stop the appliance first, then pull back the air filter.

2 Clean and reinstall the air ﬁlter. If the dirt is conspicuous, wash it with a solution

of detergent in lukewarm water. After cleaning, dry it in a shaded and cool place, then

reinstall it.

4 Clean the air ﬁlter every two weeks. If the air conditioner operates in an

extremely dusty environment.

Waste electrical products should not be disposed of with

household waste. Please recycle where facilities exist. Check

with your local authority or retailer for recycling advice

WARRANTY

ONE YEAR

AVAC9000W[15]instructions 9/4/15 09:43 Page 1

Addvent AVAC9000W Installation Instructions And User Manual

Brand: Addvent

Model: AVAC9000W

Category: Mobile air conditioners

Type: Installation Instructions And User Manual

Download PDF

report

Addvent AVAC9000W Installation Instructions And User Manual

Addvent AVAC9000W Installation Instructions And User Manual

Related papers

Other documents