Hinkley Lighting 16704MZ User manual

Brand
Hinkley Lighting
Model
16704MZ
Type
User manual
Installation Instructions
Family: Hardy Island | Item No. 167XX
All Well Lights
Start Here
HINKLEY LIGHTING 33000 Pin Oak Parkway Avon Lake, OH 44012 (p)800.442.5539 / (f) 440.653.5555 www.hinkleylighting.com
Luminaire Mounting (for typical in-ground mounting)
Lamp Replacement
1. To prevent electrical shock, turn o transformer from
electrical supply before installation or service.
2. Using a Philips head screw driver, remove top screws and
xture top. Set these aside for use in reassembly.
3. Remove silicone gasket and glass lens. Clean the glass lens
and inspect the silicone gasket for any signs of wear.
4. Gently pull upward on lamp until it releases from the
socket. Discard lamp replace with new MR16 12 volt lamp.
5. Return the silicone gasket and glass lens. Making sure the
gasket is seated correctly.
6. Screw the xture top back on. Tighten the screws so that
equal pressure is put on the gasket. Example, for the top
with four screws, screw in the top screw then the bottom,
left then right screws.
SAFETY WARNING: TURN POWER SUPPLY OFF DURING
INSTALLATION. IF NEW WIRING IS REQUIRED, CONSULT A
QUALIFIED ELECTRICIAN OR LOCAL AUTHORITY FOR
CODE REQUIREMENTS.
1. To prevent electrical shock, disconnect transformer from
electrical supply before installation or service.
2. Luminaire may be directly buried in the ground or for
concrete applications, a removable burial sleeve is
included.
3. In earth burial applications, the best way to extend xture
life is to use sand, gravel or any other material to facilitate
drainage.
4. Strip the two wire leads from the luminaire. Cut o the
green ground wire. Connect the main supply wires using
the provided silicone lled wire nuts or quick connectors
that are approved for outdoor use.
Note: Wire is to be protected by routing in close proximity to the
luminaire or tting or next to a building structure such as a
house or deck. Wiring should be buried a maximum of 6 inches
(15.2 cm) in order to connect to main supply wire. The main
supply wire must have its length cut o within 6 inches (15.2 cm)
from a building, structure, a luminaire or tting.
IMPORTANT OPERATION NOTE: This luminaire is designed
to be operated with Hinkley approved 12 volt AC systems.
Earth Burial
Concrete Burial
Route to Transformer
Cut Ground
Wire
(20w Max 12 volt MR16 Bi-pin Lamp)
Top
Silicone Gasket
Glass Lens
MR16 Lamp
Socket and
Mounting Plate
Housing
Removable Burial
Sleeve
Top Cover Options
16704
16701
16707
16710
Note: To maximize performance and life of the xture, only use
a maximum of 4 Watts when using LED lamps.
Page is loading ...
  • Page 1 1
  • Page 2 2

Hinkley Lighting 16704MZ User manual

Brand
Hinkley Lighting
Model
16704MZ
Type
User manual
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

in other languages

Related papers

Other documents