WEG KESW Installation guide

KIT KESW

13 14

DISCONNECT THE POWER AT REMOTE SOURCE BEFORE SERVICING.

ATTENTION: ALL DRAWINGS REPRESENT COMMON CONTROL. FOR

SEPARATE CONTROL, REMOVE WIRES ‘D’’& ‘C’ IF SUPPLIED AT

CONTACTOR’S TERMINALS 1L1 & 3L2, RESPECTIVELY AS WELL AS AT

THE OTHER ENDS WHERE SUCH CONTROL WIRES TERMINATE.

THEN, CONNECT THE 2 SEPARATE CONTROL WIRES WHERE WIRES ‘‘C’’

AND ‘‘D’’ WERE PREVIOUSLY TERMINATED.

RCD - REMOTE CONTROL DEVICE, CONNECTION BY THE CUSTOMER.

WIRES NOT INCLUDED.

DASHED LINES ARE CONNECTIONS TO BE DONE BY THE CUSTOMER.

OVERLOAD RELAY MUST BE SET TO FLA.

WIRES INCLUDED ON CONTROL CONNECTIONS SOLID LINES.

WIRES NOT INCLUDED ON BOTH CONTROL CONNECTIONS DOTTED LINES

AND ALL POWER CONNECTIONS. THESE ARE DONE BY THE CUSTOMER.

COMPONENT RCD NOT SUPPLIED.

25º25º

25º

A B C D E F G H I J K L M

140 15,33 32 54 241 49,69 197,5 21,98 20,8 49,2 98,4 125 121

5.51 0.60 1.26 2.12 9.49 1.95 7.77 0.86 0.82 1.94 3.87 4.92 4.76

190 15,33 32 79 330 53,4 279 28 30 65 130 142,7 138,7

7.48 0.60 1.26 3.11 12.99 2.10 10.98 1.10 1.18 2.55 5.12 5.62 5.46

240 15,33 32 104 450 72,7 384 35 40 80 160 170 166

9.45 0.60 1.26 4.09 17.71 2.86 15.12 1.38 1.57 3.15 6.30 6.69 6.53

ESW04

ESW06

ESW08

KESWPS KESWHS KESWFP KESWHP KESWPE KESWPP

10002057110.00

WEG Automação

www.weg.net