Vicon Hemispheric V9360/V9360W Series Operating instructions

Installing the V9360W Cameras to the V9360-2MK

When installing the V9360W-6 or V9360W-12 panoramic outdoor cameras to the V9360-2MK pendant

mount, it is critical to make sure that the camera installation remains watertight. After the camera

connections are completed and the camera is secured back into the mount, a bead of silicone sealant

should be applied around the entire seam where the camera base meets the pendant mount to prevent

water entry. It is recommended to use Loctite SI 595. Refer to Figure 1 below.

Figure 1

Vicon and its logo are registered trademarks of VIcon Industries Inc.

Vicon part number 8009-5289-00-00

Go to the Vicon website to ﬁnd the latest manual for the camera.

Place a small amount of silicone sealant into the seam between the two parts. Be sure to cover the

entire circumference. Carefully wipe off any excess sealant.

Download PDF