Before using the dishwasher, read the installation and maintenance instructions carefully!
1
GB
5019 696 01015
PDSX 6232
1) Programme data obtained in conformity with European standard EN 50242. The data may vary, for example, according to
different loads, extra functions, sensor settings (only with sensor programmes), water supply temperatures, water hardness
and power supply voltage.
2) Programme for energy data label in conformity with EN 50242. - Information for Test Laboratories:
for detailed information on the
EN/Standard loading comparison test and other tests, co
ntact the following address: “[email protected]”.3) The antibacterial action has been tested by the Institut Pasteur of Lille (France), based on Standard NF EN 13697 - November 2001.
1. OVERVIEW
ON button
OFF button
Programme selector
Press button P (repeatedly) until the required programme number
appears on the display.
Fault indication and wash time display
In normal operation it indicates the remaining time (h:mm),
whereas with “Delayed start” selected it indicates the time
remaining until programme start (hh).
In the presence of a fault indication “F..” –, see section “5. What to
do if...”.
Rinse aid level indicator and salt level indicator
These indicator lamps light up when rinse aid or salt need to be
added.
Only add just before starting a wash cycle.
Detergent setting
Press this button (repeatedly) to set the type of detergent used.
This deactivates the rinse aid and/or salt indicator.
Half Load/Multizone
Load the
upper
or
lower
rack
only
.
press once = wash
upper rack
(the indicator/symbol lights up)
press twice = wash
lower rack
(the indicator/symbol lights up)
press 3 times =
Off
(Half load/Multizone deactivated).
When washing without the upper rack, press the “Half load” (i.e.
“wash lower rack”) button twice; the indicator/corresponding
symbol lights up.
Powder, gel, tablets (standard): indicator off
Detergent with rinse aid: left indicator
Detergent with salt + rinse aid: right indicator
Antibacterial +
3)
This function activates an antibacterial rinse at the end of the wash
cycle, guaranteeing a further reduction of bacteria. Press the
button to activate or deactivate the function. This function can be
used with those programmes marked with the relative symbol in
table 1.1.
The dishwasher door must be kept shut for the entire duration of
the programme in order to guarantee reduction of bacteria. If the
door is opened the indicator lamp starts flashing.
D
elayed start button
Push the button (repeatedly) to delay the start of the program.
Adjustable from 1 to 24 hours. With each press of the button, the
delayed start indicator increases by one hour and after 24 restarts
from 00. Then press the START button. The wash programme will
start after the set time.
START button
The indicator lights up during operation, flashes when a fault
occurs and goes off at the end of the programme.
RESET button - for programme change or indication of faults
Press this button to cancel a started programme and selected
extra options. Press this button to cancel the main fault indicators
(F..); also refer to section “5. What to do if...”. The programme can
then be selected and started.
Table 1.1.
Table of programmes
Detergent
dispenser
Consumption
1)
P
Programmes
Available
options
Description of
programme
large small Litres kWh Minutes
1
Auto 50-65°C
Recommended programme
for routine washes, with
dried-on food (e.g. EN
50242).
X X 11-16 1.10-1.50 100-130 ±
1)
2
Pre-Wash cold
Crockery to be washed later. — — 4.0 0.03 14 ±
1)
3
Glasses 40°C
Light soiling, for example
glasses and cups.
X — 10.0 0.85 100 ±
1)
4
Quickwash 45°C
Lightly soiled crockery, with
no dried-on food.
X — 11.0 0.80 30 ±
1)
5
Eco
2)
50°C
Normally soiled crockery.
Energy Saving Programme.
X X 11.0 1.05 155 ±
1)
6
Intensive 70°C
Recommended programme
for heavily soiled crockery,
especially suitable for pans
and saucepans.
X X 14.0 1.55 155 ±
1)