Whirlpool AWT 5090 Program Chart

Brand: Whirlpool

Model: AWT 5090

Category: Washing machines

Type: Program Chart

GB AWT 5090

5019 312 10395

Programme

Care

Labels

Type of wash / Notes

Max.

Load

Detergents and Additives Special options Tempera-

ture

°C

Max.

Spin

Speed

rpm

Pre-

wash

Main

wash

Softener Bleach Rapid Half

Load

Intensive

Rinse

Hold

Cotton with prewash Heavily soiled bed linen, table linen and underwear, towels, shirts etc. made of cotton and linen. 5,0 Yes

Yes

i i

–

i i i

Max. 95 900

Synthetic with

prewash

Heavily soiled blouses, shirts, overalls etc. made of polyester (Diolen,Trevira), polyamide

(Perlon, Nylon) or blends with cotton.

2,0 Yes

Yes

– –

i i i

Max. 60 800

Delicate with prewash Heavily soiled curtains and delicate clothing, dresses, skirts, shirts and blouses. 1,5 Yes

Yes

– – – –

Max. 40 800

Cotton

Normally to heavily soiled bed linen, table linen and underwear, towels, shirts etc. made of cotton

and linen.

5,0 – Yes

i i i i i i

Max. 95 900

Coloured cotton

Normally soiled bed linen, table linen and underwear, towels, shirts etc. made of cotton and

linen.

3,0 – Yes

–

i i i i

Max. 60 900

Daily Mixed Slightly to normally soiled textiles made of cotton and/or synthetic. 3,0 – Yes

– –

i i i

Max. 60 900

Mixed Cotton /

Synthetic

Normally to heavily soiled blouses, shirts, overalls etc. made of polyester (Diolen, Trevira),

polyamide (Perlon, Nylon) or blends with cotton.

2,0 – Yes

–

i i i i

Max. 60 800

Synthetic

Normally soiled overalls and sportswear made of cotton, polyester, polyamide and blends

with cotton.

1,5 – Yes

–

i i i i

Max. 60 800

Delicate Curtains and delicate clothing, dresses, skirts, shirts and blouses. 1,5 – Yes

– – – –

Max. 40 800

Wool

Only woollens with a felt-free finish, labelled with the woolmark and identified as machine washable.

If you select “Rinse Hold” do not leave items to soak for too long.

1,0 – Yes

– – – –

Max. 40 800

Handwash

Textiles made of silk, linen, wool and viscose marked as “handwashable”.

If you select “Rinse Hold” do not leave items to soak for too long. No spinning.

1,0 – Yes

– – – –

Max. 30 –

Rinse + Gentle

Spin

– Programme for treating delicate laundry with starch or softener. 2,0 – –

– –

i i

– 800

Rinse + Spin – Programme for treating cotton or linen laundry with starch or softener. 5,0 – –

– –

i i

– 900

Spin – Programme to spin cotton or linen laundry intensively with maximum spin speed. 5,0 – – – – – – – – – 900

Gentle Spin – Programme to spin delicate laundry gently with a restricted spin speed. 2,0 – – – – – – – – – 800

Drain – Drain only - no spinning. Alternative method of terminating programme after “Rinse Hold”. – – – – – – – – – – –

A. Programme Selection Knob

B. Temperature Selection Knob

C. “Spin Speed Selection” Knob

D. “On/Off” Button

N.B. This machine is controlled by sensors. Please avoid excessive detergent dosing.

Whirlpool is a registered trademark of Whirlpool USA.

“Cold“

A DCB

i : option / Yes: dosing required

Do not use liquid detergents.

For improved garment care, spin speed is restricted

to 800 rpm in this programme.

For improved garment care, spin speed is null

in this programme.

“Rinse Hold” button

• The laundry remains in the last rinse water

without progressing to the final spin cycle to

avoid creasing and prevent colours from fading.

• This option is particularly recommended for the

“Synthetic” , “Delicate” and “Daily

Mixed” programmes.

• This function is particularly useful if you want to

postpone spinning to a later time, or if you want

to drain only.

Note: The programme selector knob stops on .

Appliance in “Rinse Hold” :

• Press the “Rinse Hold” button again: the

programme will terminate automatically with

the selected spin cycle.

• If you do not wish to spin the clothes, press the

“On/Off” button , turn the programme

selector knob to the “Drain” programme and

press the “On/Off” button again.

5019 312 10395

Programme

Temperature

Selector

(°C)

Load

(kg)

Water

(l)

Energy

(kWh)

Approx. Programme

Duration

(hours : minutes)

Cotton 95 5,0 63* 1,80 2:05

Cotton 60 5,0 55 0,95 2:05

Cotton 40 5,0 55 0,55 2:05

Daily Mixed 40 3,0 49 0,48 1:00

Synthetic 60 2,0 56 0,80 1:30

Synthetic 40 2,0 56 0,40 1:30

Delicate 40 1,5 60 0,55 0:45

Wool 40 1,0 60 0,50 0:40

Handwash 30 1,0 60 0,30 0:50

1. Load the machine, close the drum doors and

check that they are properly locked.

2. Add detergents and additives into the

dispenser to no more then the “MAX” level

mark, as follows:

• Programme with pre and main wash

• Main wash programme without prewash

• Fabric softeners and conditioners

• Chlorine bleach

• Stain remover agents

• Anti-scale agents (if necessary)

3. Turn the programme selector knob to the

desired programme.

4. Turn the temperature selector knob to the

desired temperature.

5. Turn the spin speed selector knob to the

desired spin speed. If the spin speed “ ” is

selected, the final spin is cancelled and the

programme ends with a drain cycle.

CONSUMPTION DATA

Prewash cycle increases programme duration by approximately 15 min. Consumption values were

measured in normalized conditions in compliance with standard IEC/EN 60 456. Consumption data in

the home may vary with respect to the values in the table in relation to the water supply pressure and

temperature, the load and the type of wash.

The data on the “Energy Label” refer to programme “Cotton 60°C”.

* To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the

pump drains the water out.

PREPARATION OF WASH CYCLE SELECT THE DESIRED OPTION

PROGRAMME START

Turn on the tap and press the “On/Off” button .

The indicator light of the “On/Off” button lights

up.

Note: If there is a power interruption or if the

appliance is disconnected during the cycle, the

programme will run again from the point where it

was interrupted.

END OF WASH CYCLE

• The programme selector knob is in the Stop

position.

1. Press the “On/Off” button to switch off

the machine.

2. Cancel the option.

3. Turn the tap off.

4. Wait for the lid to unlock (about 1 minute).

5. Open the lid and the drum doors and unload

the machine.

CHANGE THE PROGRAMME DURING

THE WASH CYCLE

1. Switch off machine by pressing the “On/Off”

button .

2. Select the new programme.

3. Start programme by pressing the “On/Off”

button again.

PAUSE/INTERRUPT A PROGRAMME

If, for any reason, you wish to interrupt the

programme for a certain time and continue it later:

1. Press the “On/Off” button .

2. After the desired pause, press again the

“On/Off” button .

CANCEL PROGRAMME

1. Switch off the machine by pressing the

“On/Off” button .

2. Set the programme selector to “Drain”.

3. Press the “On/Off” button again to start

the “Drain” programme .

Selecting or deselecting an option can be done

at any time during the programme. The option

will be applied as long as the corresponding

programme phase has not been executed yet.

“Rapid” button

• For fast, energy saving wash cycle.

• Ideally suited for small loads consisting of lightly

soiled laundry.

“Half Load” button

• Can be used for small loads and lightly soiled

laundry.

• Reduces the water consumption especially

during the rinse.

“Intensive Rinse” button

• The amount of water is increased to ensure a

more intensive rinse.

• This option is particulary suitable for areas with

very soft water, washing baby linen and people

with detergents allergies.

Whirlpool is a registered trademark of Whirlpool USA.

Whirlpool AWT 5090 Program Chart

Brand: Whirlpool

Model: AWT 5090

Category: Washing machines

Type: Program Chart

Download PDF

report

Whirlpool AWT 5090 Program Chart

Whirlpool AWT 5090 Program Chart

Related papers

Other documents