ASROCK Configuring a RAID Array Using UEFI User guide

Brand: ASROCK

Model: Configuring a RAID Array Using UEFI

Type: User guide

1

Configuring a RAID array Using UEFI Setup Utility

The BIOS screenshots in this guide are for reference only and may differ from the exact settings

for your motherboard. The actual setup options you will see shall depend on the motherboard

you purchase. Please refer to the product specification page of the model you are using for

information on RAID support. Because the motherboard specifications and the BIOS software

might be updated, the content of this documentation will be subject to change without notice.

STEP 1:

Enter the UEFI Setup Utility by pressing <F2> or <Del> right after you power on the computer.

STEP 2:

Go to Advanced\Storage Configuration\VMD Configuration and set Enable VMD controller to

[Enabled].

2

Then set Enable VMD Global Mapping to [Enabled]. Next, press <F10> to save the configuration

changes and exit setup.

STEP 3.

Enter Intel(R) Rapid Storage Technology in the Advanced page.

3

STEP 4:

Select the option Create RAID Volume and press <Enter>.

STEP 5:

Key-in a volume name and press <Enter>, or simply press <Enter> to accept the default name.

4

STEP 6:

Select your desired RAID Level and press <Enter>.

STEP 7:

Select the hard drives to be included in the RAID array and press <Enter>.

5

STEP 8:

Select a stripe size for the RAID array or use the default setting and press <Enter>.

STEP 9:

Select Create Volume and press <Enter> to start creating the RAID array.

6

If you want to delete a RAID volume, select the option Delete on the RAID volume info page

and press <Enter>.

*Please note that the UEFI screenshots shown in this installation guide are for reference only.

Please refer to ASRock’s website for details about each model motherboard.

https://www.asrock.com/index.asp

7

Installing Windows® on a RAID volume

After the UEFI and RAID BIOS setup, please follow the steps below.

STEP 1

Please download the drivers from ASRock's website (https://www.asrock.com/index.asp) and

unzip the files to a USB flash drive.

STEP 2

Press <F11> at system POST to launch the boot menu and choose the item “UEFI: <Windows

installation media>” to install Windows® 10 64-bit OS.

8

STEP 3 (If the drive that you plan to install Windows is available, please go to STEP 6)

If during the Windows installation process the target drive is not available, please click <Load

Driver>.

STEP 4

Click <Browse> to find the driver on your USB flash drive.

9

STEP 5

Select “Intel RST VMD Controller” and then click <Next>.

STEP 6

Select unallocated space and then click <Next>.

10

STEP 7

Please follow Windows’ installation instructions to finish the process.

STEP 8

After the Windows installation is finished, please install the Rapid Storage Technology driver

and utility from ASRock’s website. https://www.asrock.com/index.asp

1
2
3
4
5
6
7
8
9
10

ASROCK Configuring a RAID Array Using UEFI User guide

Brand: ASROCK

Model: Configuring a RAID Array Using UEFI

Type: User guide

Download PDF

Related papers