Homelive NA930 User manual

NA930OtherZWaveDeviceWizard



ToaddanonOrangeZWavedevicetothecontrolleryou’llneedtofollowthestepsbelow:



Step1.GototheDevicespageandselecttheoptiontoaddanewdevice



Step2.ThiswillbringupthesupportedOrangedevices,andatthebottomyou’llhavethe

optiontoaddnonOrangedevices.PressthattoaddotherZWavedevices:



Step3.InthegenericZWavedeviceyou’llneedtofollowthestepswhereyou’reaskedto

followtheinstructionsfromthemanualtoaddthedevicetotheunit:



IfthedeviceisbrandnewitwillbedetectedautomaticallybytheGatewayandaskyoutoname

itandmoveittoaroom:



Step4.IfthedeviceisnotbrandnewandwaspreviouslyincludedintoadifferentZWave

network,youwillhavetheoptiontostarttheExclusionwizardbypressingontheRetrybutton:



ThiswillbringuptheExclusionwizardwherecustomerisaskedtoexcludethedevice:



Oncethedeviceisdetected,you’llbenotifiedthatyoucansettheunitintoinclusionmodeto

addthedevice:



ThisiswhereyoucanrestartthewizardandsettheunitintoInclusionmodeandstartfromStep

3.