JasonL STB118PT Operating instructions

Type
Operating instructions

This manual is also suitable for

INSTALLATION GUIDE
Switch Return
Size: 1000mm x 600mm
Page 1 of 6
Need help!
Call us on
1300 527 665
www.jasonl.com.au
Note: Please ignore any pre-drilled holes or nut inserts that maybe present in your top(s). They will not match your
particular table/desk base and woods screws will be required to be screwed directly into the underside of the top.
Note: It is important to fully tighten all bolts and screws before attaching the top(s) so that the frame
is suciently rigid. Failure to do this may aect stability once the tops are attached.
Tools Required: Power screwdriver.
Table Return
Leg x2
Leg Bracket x2
Beam Bracket x2
Long Beam x1 (900mm)
Short Beam x1 (125mm)
L-Bracket x3
1
2
3
4
5
6
7
Hex Nut x3
L-Bracket screws x3
Hex Head screws x10
M8x25mm Dome Head x3
8
9
10
11
COMPONENTS
SCREWS
Page 2 of 6
INSTALLATION GUIDE
Switch Return
Size: 1000mm x 600mm
Need help!
Call us on
1300 527 665
www.jasonl.com.au
T-beam
bracket
L-beam
bracket
Leg bracket
3
1
5
7
6
2
8
4
FRAME TOP VIEW
Page 3 of 6
INSTALLATION GUIDE
Switch Return
Size: 1000mm x 600mm
Need help!
Call us on
1300 527 665
www.jasonl.com.au
Join 2 L-Bracket through each Long Beam
and 1 L-Bracket through each Short Beam.
Join Leg Brackets to each Leg using screws to secure them, as follow.
Securely connect each Beam to each Beam Bracket. Screw to secure. Insert Hex Nut on each Beam Bracket.
01
03 04
02
Page 4 of 6
INSTALLATION GUIDE
Switch Return
Size: 1000mm x 600mm
Need help!
Call us on
1300 527 665
www.jasonl.com.au
06
For the T central leg, attach as presented, using T Beam Bracket.
Position as presented, and proceed to screw to ensure each corner of the frame.
05
If this bolt does not drop into the joint
use the Allen key to screw it all the way
in so that it creates its own thread.
This will ensure a nice, tight joint.
INSTALLATION GUIDE
Switch Return
Size: 1000mm x 600mm
Need help!
Call us on
1300 527 665
www.jasonl.com.au
Attach the return structure to the main desk by screwing the tables through Joiner plate.
08
Page 5 of 6
Directly screw into return table top, using L-Bracket
screws through each L-Bracket.
07
Note: It is important to fully tighten all bolts and
screws before attaching the top(s) so that the
frame is suciently rigid. Failure to do this may
aect stability once the tops are attached.
INSTALLATION GUIDE
Switch Return
Size: 1000mm x 600mm
Need help!
Call us on
1300 527 665
www.jasonl.com.au
Page 6 of 6
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6

JasonL STB118PT Operating instructions

Type
Operating instructions
This manual is also suitable for

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI