2. D+H
  3. ZA-HV

D+H ZA-HV Operating instructions

  • Hello! I've reviewed the instructions for the Short-stroke unit for ZA actuators. It details how to install the unit, including cutting it to size, removing and reattaching the rear cover and the plastic guide element. I'm ready to answer your questions about this document or the device.
  • What is the minimum length of the short-stroke unit?
    What should be done with the cut surface of the plastic short-stroke unit?
    What is the first step in the installation process?
99.950.07 1.2/01/03
D+H Mechatronic AG • Georg-Sasse-Str. 28-32 • D-22949 Ammersbek • Tel. +49 40-605 65 219 • Fax +49 40-605 65 264
Instruction for use
2
3
1
Short-stroke unit for ZA actuators
with 12 mm GEAR RACK
Caution!
The short stroke unit must
be at least 15mm long.
1.Close the actuator completely. Then, open
for 1-2 seconds and stop.
2.Cut the plastic short-stroke unit (1) to size,
both at right-angles and to the required
length of shortened stroke.
Make sure that the cut surface is even
and square.
3.Unscrew and remove the rear cover (2)
from the tube.
4.Unscrew and remove the plastic guide
element (3) from the gear rack.
5.Slide the plastic short-stroke unit (1) into
the tube.
6.Place the plastic guide element (3) onto
the gear rack and srew it tight.
7.Reaffix the rear cover (2) to the tube and
screw it tight.
Installation
/