1 Adjustthetubetothelengthyoundmostcomfortableduringvacuumcleaning(Fig.4).
The combination nozzle can be used on either carpets or hard oors.
1 Connect the combination nozzle to the tube.
2 Tocleanhardoors,pushtherockerswitchontopofthecombinationnozzlewithyour
foot. The brush strip comes out of the nozzle housing. (Fig. 5)
3 To clean carpets, push the rocker switch again to make the brush strip disappear into the
nozzle housing again. (Fig. 6)
- The Reach & Clean nozzle can be used on either carpets or hard oors. The nozzle can be
turned 360 degrees to 4 different positions, allowing you to vacuum large areas as well as hard-
to-reach places in an easy way. When the nozzle is positioned lengthwise, the suction power is
concentrated at the front side of the nozzle (Fig. 7).
- To adjust the nozzle to the type of oor and the area to be cleaned, put your foot on the
indicated spot. Then turn the tube until the nozzle is in the required position (Fig. 8).
1 Connect the Reach & Clean nozzle to the tube.
2 Withthenozzlepositionedbreadthwiseandthebrushstripfoldedout,youcanvacuumlarge
hardoorareas.Turnthetubeuntilthebrushstrippopsoutofthenozzlehousingandthe
nozzle is positioned breadthwise (Fig. 9).
3 Withthenozzlepositionedlengthwiseandthebrushstripfoldedout,youcanvacuumsmall
hardoorareas.Turnthetube90degreesanticlockwiseuntilthenozzleispositioned
lengthwise with the brush strip still folded out of the nozzle housing (Fig. 10).
4 Withthenozzlepositionedbreadthwiseandthebrushstripfoldedin,youcanvacuumlarge
softoorareas.Turnthetube90degreesanticlockwiseagaintopositionthenozzle
breadthwise and to make the brush strip disappear into the nozzle housing (Fig. 11).
5 Withthenozzlepositionedlengthwiseandthebrushstripfoldedin,youcanvacuumsmall
softoorareas.Turnthetube90degreesanticlockwiseagainuntilthenozzleispositioned
lengthwise with the brush strip still folded in (Fig. 12).
1 Connectthecrevicetool,smallnozzleorsmallbrushdirectlytothehandgriportothetube.
The accessory clip can simply be snapped onto the tube.
- The crevice tool and the small nozzle can be snapped onto the clip (Fig. 13).
Vacuuming
1 Pull the cord out of the appliance and put the mains plug in the wall socket (Fig. 14).
2 Push the on/off button on top of the appliance with your foot to switch on the appliance.
3 The appliance can be carried in two ways:
- You can carry the vacuum cleaner vertically by the handle on the front of the appliance (Fig. 15).
ENGLISH 7