Telefunken TB 351 Owner's manual

TELEFUNKEN TB 300 City

TB 301, TB 302, TB 351 & TB 352, TB 303 & TB 353

GUIDE DE DEMARRAGE RAPIDE

QUICK START GUIDE

KURZANLEITUNG

GUIA DE INICIO RAPIDO

Page is loading ...

2

Important information

This document is only a quick-start guide. Full

operating instructions are available on the

website www.telefunken-digital.com.

Box contents



1 cordless handset



1 telephone base



1 AC adapter



1 RJ11 telephone cord



2 rechargeable AAA NiMH batteries



1 quick-start guide

Siting the base

A site should be chosen with the following

characteristics:



A flat and stable surface



At most 2 metres from a power outlet and a

telephone jack



At least 1 metre from any other electronic

appliance to avoid interference



Out of direct sunlight and a sufficient

distance from any heat source



Away from any wet or damp area, such as a

bathroom

Note: since the base and the portable handset

communicate via radio waves, it is important

that the base is located in an open area to

ensure the best possible signal. The normal

range is approximately 300 metres when there

is a direct line of sight to the base, and

approximately 50 metres when the base is

indoors and the phone is outdoors. Thick

concrete walls significantly reduce this range.

The symbol on the portable handset

indicates when you are in range of the base.

Whenever you are outside range of the base,

the symbol blinks, and a warning tone is

emitted.

Connecting the base

1. Under the base, plug the power cord

holding a clear connector in the plug

labelled .

2. Connect the other end of the power cord

into the power wall outlet. The device

switches on, as indicated by the green light

from the base.

3. Under the base, connect the telephone jack

to the plug labelled and the other end

into the telephone connector plug. Then

plug the connector to the telephone wall

jack.

4. Verify that the green light of the base is lit.

Recharging the handset

1. On the handset, slide the cover and insert

the 2 NiMH batteries supplied. Always

observe the direction of insertion. Close the

lid.

2. Place the handset on the base and allow

charging for at least 24 hours before its first

use, until the handset icon indicates .

3. If necessary, do the same for other

handsets.

3

Handset

5. TALK

Press to make and receive calls.

6. END CALL / POWER ON OFF

Press to end call or go back to the main

screen.

Press and hold to switch the handset on/off

7. TOUCHE DIRECTIONNELLE BAS

Press to open and scroll through the Calls

list.

Decrease earpiece volume.

8. KEYPAD LOCK

Use to lock/unlock the keypad to prevent

accidental dialling.

9. TOUCHE #

Press to stop an OGM record.

10. R

Use with switchboard services and some

network services.

11. INT

Use to make internal calls and transfer calls

to other.

Balance handsets registered to the base

12. REDIAL

Press to redial the last called number.

1. EARPIECE

2. UP KEY

Scroll through options.

Increase earpiece volume.

3. OK/MENU

Press to open the menu,

Press this key to select an option of the menu

and to validate a choice.

4. PHONEBOOK

Press this key to display the phonebook.

Use this key to go back in a menu or erase a

typed number.

4

Base (without Answering Machine TB 301-TB 302)

1. FIND HANDSET

Press to find misplaced handsets

registered to the base.

Use to register handsets and de-register

handsets registered to the base.

2. CHARGING CONTACTS

Base (with Answering Machine TB 351 – TB 352)

1. INCREASE THE VOLUME

2. DECREASE THE VOLUME

3. PREVIOUS

Press to skip backward through your

answering machine messages. Press to

turn message alert on/off.

4. POWER ON/OFF

Switches the answering machine on/off.

Announces the current OGM.

5. PLAY/PAUSE

Play or pause recorded messages.

Press to play new messages or press and

hold to play all messages.

6. STOP

Stops message playback.

Press to announce the current day and time

setting.

7. SUPP.

Press to delete recorded messages during

playback.

8. NEXT

Press to skip forward through your

answering machine messages.

Press to announce the current answer delay

setting.

9. FIND HANDSET

Press to find misplaced handsets registered

to the base.

Use to register handsets and de-register

handsets registered to the base.

9

5

Handset icons

Flashes to indicate an incoming

external call

External call in progress

Flashes to indicate an incoming

internal call

Internal call in progress

3 Way call in progress or transfer

external call to another Balance

handset registered to the base during

an external call

Indicates signal strength

Flashes when handset is not

registered to the base or if you go out

of range

Menu open

Phonebook open

Flashes to indicate new calls list

entries received*

Answered call (when viewing the Calls

list)*

Unanswered call (when viewing the

Calls list)*

Keypad locked

◄ ►

The displayed number is longer than

12 digits

Battery charge full

Battery charge medium

Battery charge low

Flashing - Battery charge nearly empty

TELEPHONING

Making a call

- In direct dialing

1. Press .

2. Wait for the dial tone and then dial the

number.

- In pre-dialling

1. Dial the number. In case of error, press

.

2. Press : the number is dialled.

3. Press again to make a HF call.

Ending a call

1. Press .

Once the handset is replaced, the call

duration is displayed for 15 seconds.

Internal calls

- Calling another handset

If you have more than one handset registered

to the database, you can make internal calls

between two handsets.

1. Press the button (bottom right of

keypad) followed by the number of the

handset number (1 to 5) that you wish to

call.

2. Press OK to dial.

Note: When receiving an internal call, the

display shows .

6

- Transferring a call

You can transfer an external call to another

handset registered on the base.

During the call:

1. Press the button followed by the

number of the handset number (1 to 5) that

you wish to call.

2. Press to end the transfer or press

to switch between the two callers.

Answering a call

Upon receipt of an external call, the handset

rings. The screen displays and the

subscriber number or, if the number is stored in

the phonebook, the caller’s name.

1. When the handset rings, press .

Note: an incoming call has priority over other

events. Thus, any operations in progress such

as phone setting, menu navigation, are

immediately discontinued.

Adjusting the volume

During the conversation, press  or  to

adjust the volume of the earpiece or

loudspeaker.

Locking the keypad

Press and hold the button. The display

shows .

Unlocking the keypad

Within three seconds after pressing any button,

press .

With a locked keypad, it is always possible to

answer incoming calls.

PHONEBOOK

The handset's phonebook can hold up to 50

names and telephone numbers. The numbers

can have up to 20 digits, and names can have

up to 12 characters.

Adding a contact

1. Press . The display shows phone

book, press .

2. The display shows Add Entry. Press .

3. The display shows Name ?. Use the keypad

to enter the name and press .

4. The display shows Number ?. Use the

keypad to enter the phone number and

press .

5. The display shows Melody 1. Press ▲ or ▼

to select the ringtone you want.

Deleting a contact

1. Press . The display shows Phone

Book, press .

7

2. Scroll ▲ or ▼ to Delete Entry and press

.

3. Scroll ▲ or ▼ to the entry you want delete,

or search alphabetically.

4. Press . The display shows Confirm ?.

5. Press to confirm or to cancel.

ANSWERING MACHINE

When activated, the voicemail of the TB 351 /

TB 352 stores messages for unanswered calls.

A maximum of 13 minutes can be stored.

Setting the day

1. Press , scroll ▼to Tam Settings and

press to confirm.

2. Scroll ▼ to Day Setting and press .

The current day is displayed.

3. Press ▼ or ▲ to select the required day

and press to confirm.

Setting the time

1. Press , scroll ▼ to Date-Time and

press .

2. Scroll ▼ to Clock Set and press . The

current time is displayed.

3. Use the keypad to set the required time in

24 hour format, e.g. 18-30 for 6.30pm.

4. Press to confirm.

Checking the current day and

time setting

Press . The current day and time setting

is announced.

Activating/deactivating the

voicemail

- From the handset

1. Press , scroll ▼ to Tam Settings and

press .

2. Ans On/Off is displayed, press .

3. Press ▼ or ▲ to select either ON or OFF

and press .

- From the base

1. Press . The new setting is announced.

Recording an announcement

An announcement is the message which will

first be heard by the caller after the call is

detected by the voicemail. You can select one

8

of two pre-recorded messages or similarly

record your own message.

- From the handset

1. Press , scroll ▼ to Tam Settings and

press .

2. Scroll ▼ to Ogm Setting and press .

3. Scroll ▼ to Record Ogm and press .

4. Press ▼ or ▲ to select either Ans And Rec

or Ans Only and press .

5. Place the handset at your ear. You will hear

Please speak after the tone. To end

recording, press #.

6. After the long beep speak your message

slowly and clearly into the handset, to end

recording press . Your message will

then be played back to you through the

handset.

Listening to messages

- From the base

Press . The number of new messages is

announced and the new message(s) will be

played.

Or

Press and hold and the numbers of all

(new and old) messages are announced. The

oldest message is played first.

During playback:

Press to pause a message. You will hear

a beep every 10 seconds.

Press again to resume playback.

Press to play the next message.

Press once to repeat the current

message.

Press twice to play the previous

message.

Press to delete the current message. You

will hear Message deleted.

Press and hold to play messages at 1.5

times normal speed. Release the button to

continue playback at normal speed.

Press to return to the current answering

machine mode On or Off.

- From the handset

1. Press . Play Message is displayed,

press .

2. New Msg is displayed and the number of

new messages.

9

3. Press to play new messages only or

scroll ▼ to All Msg and press to

play all of your messages. You will need to

place the handset to your ear to hear the

message(s).

During playback:

Press ▼ or ▲ to adjust the playback volume.

Press or once to repeat the

current message.

Press or twice to play the

previous message.

Press or to play the next

message.

Press to delete the current message.

You will hear Message Deleted.

At the end of playback:

You will hear End of messages. To delete all

messages, press delete. To delete all

messages, press , you will hear, All

messages deleted.

WARRANTY

This telephone comes with a 24-month

warranty, starting from the date the phone was

purchased.

For more information on the applicability of this

warranty, please refer to the full operating

instructions available on the website

www.telefunken-digital.com

After-Sales Service Contact

In the event of a technical problem, feel free to

contact our after-sales service.

[email protected] or +33 (0)5 456 082 51

(International Number)

Page is loading ...

Telefunken TB 351 Owner's manual

Telefunken TB 351 Owner's manual

in other languages

Related papers

Other documents