2. Spectrum Industries
  3. 99051B

Spectrum Industries 99051B Installation guide

  • Hello! I've reviewed the installation instructions for the Spectrum Cooling Fan Media Manager Series 99051. This document details how to properly install the fan inside your lectern, including the steps for connecting the power cord and securing the assembly for optimal efficiency. I'm here to answer any questions you have about the installation process or the fan itself.
  • What should I do if parts are missing or damaged?
    Where should the cooling fan be installed?
    What type of screws are used to install the fan?
Assembly Instructions
0190411 Page 1 of 1
925 FIRST AVENUE, CHIPPEWA FALLS, WI 54729 / 800-235-1262 / 715-723-6750 / WWW.SPECTRUMFURNITURE.COM
© 2017 Spectrum Industries Inc., All rights reserved.
Assembly Instructions
Important
Before you begin, read and comply with all safety and operating instructions,
and ensure all parts and correct quantities are included.
Any parts damaged during shipment must be reported within 5 days of receipt.
To report information regarding missing parts or damage, to purchase parts
or accessories, or if you have any questions, please contact us.
www.spectrumfurniture.com
800-235-1262, 715-723-6750
Thank you for purchasing Spectrum products!
Cooling Fan
for Media Manager Series Lecterns
99051
(1) 0132742
Fan assembly
(1) 0109399
Fan power cord
Installation
1. With two-prong end disconnected, plug the fan power cord into the fan socket. Figure 1.
2. Remove the student-side panel of the lectern (requires key) and set panel aside.
3. Align the fan assembly mounting holes with the center vent slot. Figure 2.
4. From the outside, install (2) 10-24 x 1/2” THM screws to secure.
5. Tighten screws securely.
6. Plug the two-prong plug end of the power cord into an AC outlet.
7. Replace student-side panel.
Figure 1
Fan assembly
Tools
Required
Phillips
screwdriver
(2) 059533
10-24 x 1/2” THMS Note: The fan is setup in an exhaust conguration. To maximize efciency,
it should be installed inside the lectern above the rack cabinet.
Plug the fan
power cord into
socket here
Figure 2
(2) 10-24 x 1/2”
THM Screws
Fan assembly
Center vent slot
/