partyrent com 3112 User manual

User manual 3112 Beer air-cooler Linus40 with drip plate

Safety instructions:

• Do not place the device in the immediate vicinity of flammable objects.

• Place the device on a flat and horizontal surface.

• Never cover the entire device or the ventilation openings during use.

• Never leave the powered device turned on unattended.

• Make sure that the mains plug and all electrical components (if not designed for this purpose) do not

come into contact with water.

• Always have electrical installations commissioned by a specialist.

• Local regulations and standards must be observed during installation.

• Do not use devices with a damaged power cord.

• Never disconnect the mains connection by pulling the cable. So always grab the plug

to disconnect the mains connection.

• Some parts of the device may become hot during use.

• Only transport the device when it is switched off.

Switch on:

1. Place the beer cooler on the bar and connect the two beer pipes from the beer cooler to a KEG

coupling (not included).

2. Connect the pressure gauge to a CO2 bottle using the screw thread and connect the two hoses to the

KEG coupling.

3. Connect the KEG coupling to the kegs.

4. Open the CO2 bottle (fully open; risk of freezing) and shut-off valve on the manometer.

5. Connect the beer cooler to the power source.

Switch off:

1. Disconnect the device from the power source.

2. Close the CO2 bottle and the valves on the pressure gauge.

3. Disconnect the KEG coupling from the kegs and also the hoses to the manometer and the cooler (keep

them screwed to the cooler).

4. Unscrew the pressure gauge from the CO2 bottle (the two hoses remain screwed to the pressure gauge

here).