BLOTZ B28-ST-125 Assembly Instructions

Hello! I've reviewed the document for the 28mm Park Bench B28-ST-125. It outlines the assembly process, mentioning the need for PVA glue, a modeling knife, and sandpaper. The bench is constructed from four pieces. I'm here to assist you with any questions you have about its assembly or features.
What type of glue is required for assembly?

What tool is needed to remove parts from the sprue?

What can be used to hold pieces together while the glue dries?

28mm Park Benches

B28-ST-125

Please read these instructions fully before starting construction.

PVA or equivalent glue will be required to stick sections together.

Sand paper can be used to gently clean any joints.

A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember

to cut away from yourself at all times.

During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while

you allow glue to dry.

Each bench is made up of the four pieces shown

above.

Insert the seat and backrest to one of the sides. The

sprue points on these should be towards the

back/bottom respectively.

Finally, attach the other side piece.