2. Primex
  3. SpeedStar Cat5e Jack

Primex SpeedStar Cat5e Jack Installation guide

  • Hello! I've reviewed the installation instructions for the Primex Cat5e Jack 2-7001. This document outlines the process of preparing the cable, connecting it to the jack, and mounting it to a faceplate. I'm here to help with any questions you have about the installation process or the features of this product.
  • How much of the cable jacket should be stripped?
    How far should wire pairs be untwisted?
    What tool should be used to terminate the conductors?
Fit everything. Together.
2-7001 Cat5e Jack
P/N 135-0179
Strip outer jacket of cable 1 ½” being
careful not to nick the insulation of the
individual conductors.
Terminate conductors using impact tool.
Trim excess conductors and discard.
Install IDC cap.
SpeedStar installation: Snap the bezel onto the
connector and then snap the connector into the
faceplate from the back side.
Insert conductors into the color coded slots
on IDC. Do not untwist wire pairs more than
0.4” from back of the connector.
Cut
814B
/