GENMAX GM9000PK User manual

Brand
GENMAX
Model
GM9000PK
Category
Motorcycle Accessories
Type
User manual

Below you will find brief information for GM9000PK. This parallel kit is designed for use with GENMAX inverter generators. It allows you to connect two generators to increase power output. The manual provides instructions on how to correctly install and operate the kit, including safety precautions and steps for connecting and disconnecting the cables. Pay attention to connecting the ground wires and turning the low idle switches on or off as needed to prevent voltage fluctuations. Always refer to the owner's manual for your specific generator models.

Below you will find brief information for GM9000PK. This parallel kit is designed for use with GENMAX inverter generators. It allows you to connect two generators to increase power output. The manual provides instructions on how to correctly install and operate the kit, including safety precautions and steps for connecting and disconnecting the cables. Pay attention to connecting the ground wires and turning the low idle switches on or off as needed to prevent voltage fluctuations. Always refer to the owner's manual for your specific generator models.

Works with 50A parallel kits
This parallel kit is intended to be used only with GENMAX inverter generators.
Please read safety information below before proceeding.
1. Make sure both engine switches are in the off position, and conrm the
Low idle switches on both generators are turned off.
2. Connect the black and red parallel cable leads to the black parallel ports
on each corresponding inverters control panel. DO NOT connect two red
leads or two black leads into the same inverter.
3. Attach the ground terminal (green wire) from each end of the parallel
cable to the corresponding ground terminal on each generator.Connect
and tighten the ground wire.
4. Start each generator and conrm that the green output indicator is
illuminated on both.
5. If using Low idle mode, turn both Low idle switches on after the
generators are started.
6. To shut down, turn off both generators and then remove the parallel
cords.
Installation and Operation:
Operating a generator can be dangerous if used improperly.
Always refer to owners manual for safe and proper operation of
the generator.
R
Inverter Parallel Kit Operation
WARNING
MODLE: GM9000PK
R
MODLE: GM9000PK
If high electrical loads are connected, turn the Low idle switch to the OFF
position to reduce voltage changes. With the generators running, make
sure both green output indicator lights are ON. If not ON, turn the
generators off, restart the generators, and make sure both green output
lights are ON.
ConnectorsRed
ConnectorsRed
Ground Connectors (Ring)
Ground Connectors (Ring)
Round Connector (Black)
Round Connector (Black)
Square Connector (Black)
Square Connector (Black)
NOTICE
  • Page 1 1
  • Page 2 2

GENMAX GM9000PK User manual

Brand
GENMAX
Model
GM9000PK
Category
Motorcycle Accessories
Type
User manual

Below you will find brief information for GM9000PK. This parallel kit is designed for use with GENMAX inverter generators. It allows you to connect two generators to increase power output. The manual provides instructions on how to correctly install and operate the kit, including safety precautions and steps for connecting and disconnecting the cables. Pay attention to connecting the ground wires and turning the low idle switches on or off as needed to prevent voltage fluctuations. Always refer to the owner's manual for your specific generator models.

Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents