Pyle AZPUCVCBAT48 User manual

Pyle
Brand
Pyle
Model
AZPUCVCBAT48
Category
Vacuum cleaners
Type
User manual

This manual is also suitable for

www.PyleUSA.com
IMPORTANT SAFE GUARDS
When using an electrical appliance, basic safety preacautions observed, including following
Read all Instructions Before Using your Vacuum Cleaner
Warning: To reduce the risk of re, electrical shock, or injury
1. This product is intended for household use only. Do not use outdoors or on wet surface.
2. Do not allow to be used as a toy. Close attention is necessary when used by or near children.
3. Use only as described in this manual. Use only manufacturer's recommended attachments.
4. Do not use vacuum if it has been dropped, damaged, left outdoors, or dropped in water.
Contact customer services for advice.
5. Do not handle plug or appliance with wet hands.
6. Do not put any objects into openings. Do not use with any opening blocked, keep
free of dust, lint, hair and anything that may reduce air ow.
7. Keep hair, clothing, ngers, and all parts of the body clear of moving parts.
8. Do not pick up anything that is ammable, burning or smoking.
9. Use extra care when cleaning on the stairs
10. Do not use to pick up ammable or combustible liquids such as gasoline or use in
areas where they may be present.
11. Do not operate this appliance for anything other than its intended use.
12. Keep end of hose, wands and other openings away from your face and body.
13. Do. not use the vacuum cleaner without dust cup lter in place.
14. Always unplug this appliance before connecting or disconnecting vacuum hose.
15. Store the vacuum indoors. Put the vacuum away after using to prevent tripping accidents.
16. Using incorrect battery will damage motor. Please use the recommended batteries.
17. Use only on dry indoor surfaces
18. Use only as described and for the uses described in this manual
19. If the supply cord is damaged, it must be replaced by the manufacturer or its service agent
or a similarly qualied person in order to avoid a hazard.
1
www.PyleUSA.com
VACUUM CLEANER
PUCVCBAT48
1. AIR TURBO BRUSH
2. ALUMINUM TUBE
3. TUBE RELEASE BUTTON
4. BODY RELEASE BUTTON
5. INDICATOR LIGHT
6. POWER SWITCH
7. DUST CUP
10
11
12
13
1
2
3
4
5
6
7
8
9
DUST CUP SET
Dust Cup
Release Button
14
Plastic Centering
Filter System
Dust Cup
Dust Cup
Bottom
Dust Cup Cover
for Air Exhaust
Dust Cup Cover
8. DUST TANK UPPER PART RELEASE BUTTON
9. DUST TANK BOTTON RELEASE BUTTON
10. MULTI CREVICE NOZZLE
11. TRANSFORMATION JOINT
12. CHARGER
13. CHARGING SEAT
14. HV COTTON SPONGE W/ HEPA FILTER
2
www.PyleUSA.com
PRECAUTIONARY MEASURES
If the opening that suck in the air, the brush or extension tubes are blocked, you should switch
o the vacuum cleaner at once. First clear the blocked substance before you attempt to start
the vacuum cleaner again.
ASSEMBLING VACUUM CLEANER
1. Do not operate the
vacuum cleaner too close
to heaters, radiators,
cigarette butts etc.
2. Before you start using
the vacuum cleaner,
please remove large or
sharp objects from the
oor in order to prevent
damage on lter. Do not
use the vacuum to clean
anything that is amable
such as gas and
cigarettes.
Installing the Main Brush
Insert the main brush into
the main frame as shown
on the diagram
3
www.PyleUSA.com
1.Push Here
2. Move
Figure A
Figure B
Installing the Conversion
Connector
Use the Conversion joint
to connect the body
accesories
Install Extended Aluminum
Tube
Use the aluminum tube for a
longer head of connection
machine and then the other
side of the pipe to connect
accessories (right), to use it as
vertical vacuum cleaner:
* connect the tube to shangdi
brush to use directly to clean
the oor or carpet.
* connect the tube to the
brush or at after absorption,
can be used to clean the
ceiling, curtains, or any higher
place hard to reach spaces.
Remove and install the Dust
Cup
(a) Remove dust cup from
body: push the release button
of dust cup. Then take out the
dust cup from body. (g. A)
(b) Install dust cup on body:
connect the underside of
dust cup to the body. (pls pay
attention to the tting
position and direction). Then
push the dust cup to attach
with the body. The dust cup
will be locked after a
voice of “kata”.(g.B).
4
www.PyleUSA.com
1. Push
Push
Figure A
Figure B
Installation and
Removing the Battery
pack
* Removing the battery
pack: Push down to
remove battery pack
(FIG. A)
* Installing the battery
pack: Push the battery
pack upside. You will hear
a crack sound to conrm
the battery pack is
attached. (FIG. B)
CLEAN UP THE CHARGING CLEANER AND CLEANER
A.How to drop dust and clean
the dust cup
1. Remove the dust cup from
body.
2. Press the dust cup bottom to
release the dust to fall down
automatically. (g. A)
3. If the plastic lter system is
too dirty, please press the dust
cup cover (for air exhaust)
release button, take out the
lter assembly out of the dust
cup, then clean with soft brush
or wash with water. You should
dry them completely before
using it again. (g.B).
5
www.PyleUSA.com
B.Changing or Cleaning the HV
Cotton Sponge w/ HEPA Filter
1. Remove the dust cup from
body.
2. Rotate the dust cup cover
counter clockwise from “close” to
“open”, take out the dust cup
cover. Draw out the sponge and
HEPA lter set. (g. A)
3. Pull up the knob of the lter
frame, and pull out the sponge
lter and HEPA lter from the
case box. Clean the Sponge and
HEPA lter by a soft brush or rinse
in lukewarm water and dry them
completely before using again.
All the lters are washable. (we
recommend you to clean the
lters when feeling the suction
power if becoming weak.) (g.B)
Note: The above lters should be
attached in correct places before
using the vacuum machine
C. Charging the product
1. Charge the appliance indoors
and connect it to the outlet.
2. Charge the unit and place it in
a safe corner to prevent accident
Note: It is necessary to clean the lters regularly with frequent use in order to maintain
suction performance and prolong the life span of your cleaner.
6
www.PyleUSA.com
TROUBLESHOOTING GUIDE
PROBLEM POSSIBLE REASON POSSIBLE SOLUTION
Machine doesn't work
The machine can't
suck or suction the
is very weak
Dust escaping from
vacuum
Vacuum brush wont
pickup
The battery may be drained
or low batt
1. The DUST CUP may be full
2. Lack of battery power
1. Dust cup is full.
2.The dust lter dust cup
and cup bottom may not be
attached properly
1. Dust cup is full.
Charge the battery or
replace it with a full charged
battery.
1. Empty dust cup
2.Connect the charger.
1. Empty the dust cup
2. Check and see if the dust at
the bottom of the cup is
locked
1.Empty and clean dust cup
container.
7
  • Page 1 1
  • Page 2 2
  • Page 3 3
  • Page 4 4
  • Page 5 5
  • Page 6 6
  • Page 7 7
  • Page 8 8

Pyle AZPUCVCBAT48 User manual

Pyle
Brand
Pyle
Model
AZPUCVCBAT48
Category
Vacuum cleaners
Type
User manual
This manual is also suitable for
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents