2 CLOSE
3 CLOSE
4 HOSE
COMPRESSOR START UP
Note: Plug Cord directly into wall.
Extension cord not recommended,
use longer hose instead. See manual.
WARNING
To prevent serious injury,
read manual before use.
20 GALLON
OIL LUBE
VERTICAL AIR
COMPRESSOR
1 ADD OIL
7 ADJUST
5 PLUG IN
6 ON
For best performance,
use 30wt non-detergent
compressor oil
20 GALLON 135 PSI OIL LUBE
VERTICAL AIR COMPRESSOR
Troubleshooting Guide
POSSIBLE CAUSES LIKELY SOLUTIONS
OVERHEATING
Extension Cord Use
Plug directly into power and
run longer hose to work.
Shared Circuit
Move to circuit not currently
running other tools.
Poor ventilation.
Move the compressor to
an area with better air circulation.
Dirty air intake lter or cooling surfaces. Clean air intake lter and cooling surfaces.
Compressor undersized for application. Check air requirements of tools.
COMPRESSOR OPERATES, BUT WITH LOW AIR OUTPUT
Valve or regulator loose or leaking. Repair leaks.
Valve, piston rings, or
regulator damaged.
Have components repaired by
a qualied technician.
Air tank not pressurized yet.
Close drain valve and allow
pressure to build.
INCORRECT PRESSURE GAUGE READING
Pressure gauge worn or damaged.
Have pressure gauge replaced
by a qualied technician.
Note: If unit automatically shuts off before reaching its
cutoff pressure: Turn Power Switch off, unplug unit,
wait 10 minutes, plug in unit, then turn Power Switch on.
-
1
-
2
McGraw Item 64857 Quick start guide
- Type
- Quick start guide
- This manual is also suitable for
Ask a question and I''ll find the answer in the document
Finding information in a document is now easier with AI
Other documents
-
Porter-Cable CLFRP350 User manual
-
-
-
-
-
Porter Cable CPLDC2541S Owner's manual
-
Craftsman 921.1521 User manual
-
-
Central Pneumatic Item 61489 Owner's manual
-