Insignia NS-EK17BK9 Quick setup guide

Insignia
Brand
Insignia
Model
NS-EK17BK9
Category
Electric kettles
Type
Quick setup guide
USING YOUR ELECTRIC KETTLE
1 Pull the power cord out of the power base, then connect the
plug to a power outlet.
Note: The power cord is stored in the power base and can be
adjusted to the length you need.
2 Press the power switch down to turn on the kettle. The light
turns on and the water begins to heat.
After the water has boiled, the kettle turns o automatically and
the light turns o.
To shut o the power, lift the power switch to the o position.
Note: Make sure that the power switch is clear of obstructions and
the lid is rmly closed. Otherwise, your kettle will not turn o.
3 Lift the kettle from the base, then pour the water.
Note: The kettle will not re-boil until the switch is turned on. Let the
kettle cool for 15~20 seconds before trying to reheat the water.
WARNINGS:
• Use caution when pouring the water from your kettle. Contacting
boiling water may result in a serious burn.
• Do not open the lid while the water in the kettle is hot.
Boil-dry protection
If you try to operate the kettle without water, the boil-dry protection
automatically turns it o. If this should occur, let your kettle cool before
lling with cold water.
FILLING YOUR ELECTRIC KETTLE
Notes:
• Before using your electric kettle for the rst time, clean your kettle by
boiling two full kettles of water, then discarding the water.
• Never ll the kettle with any liquid other than water.
1 Place the base on a at, heat resistant surface, as close as
possible to a power outlet.
2 Remove the kettle from the base and open the lid by pulling up
on the recessed handle on the lid.
3 Fill with the desired amount of water.
4 Close the lid. Place the kettle on the base, making sure that the
kettle contacts the base completely.
Before using your new product, please read these instructions to prevent any damage.
PACKAGE CONTENTS
• 1.7 L electric kettle
• Power base with power cord
Note: The base and cord are packaged inside the kettle for
shipping.
• Quick Setup Guide
QUICK SETUP GUIDE
1.7-Liter
Electric Kettle
NS-EK17BK9
FEATURES
• Cordless kettle lifts from a corded base to easily ll and serve
hot water
• Cord stores inside the base and adjusts to the length you need
• Locking lid stays in place while you pour
• Blue illuminated power switch silently turns o after your water
boils
• Auto-shuto prevents your kettle from boiling dry
• BPA-free materials keep your family safe from contaminants
• 1.7 L (1.8 qt) capacity heats enough water for everyone
• Water level indicator measures the water in your kettle
• 1500W of power boils a full kettle (1.7 L/1.8 qt) in eight minutes
and .5 qt (.5 L) in three minutes
1.7L
MAX
1.0L
0.5L
MIN
Notes:
• Always ll the kettle between the minimum (0.5L)
and maximum (1.7L) marks. Too little water results
in the kettle turning o before the water has
boiled. Too much water results in boiling water
ejecting.
• Make sure that the lid is rmly in place before
connecting the power cord to the outlet.
ON
OFF
Power switch
and light
Lid
Spout
Recessed handle
Handle
Power switch & light
Power cordPower base
TROUBLESHOOTING
Do not try to repair your kettle yourself. Doing so invalidates the
warranty. If problems persist after you try the solutions below, contact
Best Buy technical support.
V4 ENGLISH 19-0292
CLEANING AND MAINTAINING YOUR ELECTRIC
KETTLE
• Always unplug the power cord and let your kettle cool down
completely before cleaning.
• Never immerse your kettle, cord, or base in water, or let
moisture come in contact with these parts.
• Do not use chemicals, steel wool, or abrasive cleaners to clean
the outside of your kettle. These substances can scratch the
surface or fade the color.
Removing mineral deposits
1 Fill your kettle with three cups of white vinegar and the
remainder with water and let it stand overnight. Do not boil.
2 Empty the solution from your kettle. Remove remaining stains
with a damp cloth.
3 Boil two full kettles of water, then discard the water.
Cleaning the outside
Wipe the outside of your kettle with a damp cloth or sponge.
STORING YOUR ELECTRIC KETTLE
You can store your kettle on the base when you are not using it.
Note: Make sure that the power cord is unplugged when your kettle is
not in use. When you unplug the power cord, it retracts into the power
base.
SPECIFICATIONS
• Dimensions (H×W×D): 9.3 × 7.9 × 5.4 in. (23.5 × 20 × 13.8 cm)
• Weight: 1.5 lbs (.7 kg)
• Capacity: 1.7 L (1.8 qt)
• Power requirements: 1500W
IMPORTANT SAFETY INSTRUCTIONS
When using electrical appliances, basic safety precautions should always be followed, including the following:
1 Read all instructions.
2 Do not touch hot surfaces. Use handles or knobs.
3 To protect against re, electric shock, and injury to persons, do not immerse cord, plugs, or your kettle in
water or other liquid.
4 Close supervision is necessary when using your kettle by or near children.
5 Unplug your kettle from the power outlet when not in use and before cleaning. Let it cool before putting
on or taking o parts and before cleaning your kettle.
6 Do not operate your kettle with a damaged cord or plug or after your kettle malfunctions or has been
damaged in any manner. Return your kettle to the nearest authorized service facility for examination,
repair, or adjustment.
7 The use of accessory attachments not recommended by your kettle's manufacturer may result in re,
electric shock, or injury to persons.
8 Do not use outdoors.
9 Do not let the cord hang over the edge of a table or counter or let it touch hot surfaces.
10 Do not place your kettle on or near a hot gas or electric burner or in a heated oven.
11 Do not use your kettle for other than its intended use.
12 Always attach the plug to the kettle rst, then plug the cord into the wall outlet. To disconnect, turn the
kettle o, then remove the plug from the wall outlet.
13 Do not attempt to modify or extend the power cord.
14 Do not handle the plug with wet hands. This could result in an electric shock.
15 Unplug the power cord by holding the plug, never by pulling the cord.
16 Your kettle has a polarized plug (one blade is wider than the other). To reduce the risk of electric shock, this plug
is intended to t into a polarized outlet only one way. If the plug does not t fully into the outlet, reverse
the plug. If it still does not t, contact a qualied electrician. Do not attempt to modify the plug in any way.
17 Scalding may occur if the lid is removed during the brewing cycle.
18 The provided power cord is short to reduce the risk of becoming entangled in or tripping over the cord.
• If you use an extension cord, it should be arranged so that it will not drape over the counter or table top
where it could be pulled on by children or tripped over unintentionally.
19 If you use an extension cord, make sure that:
• The marked electrical rating of the extension cord is at least as great as the electrical rating of your kettle.
• The extension cord is not draped over a counter or table top where children can pull it or trip over it.
PROBLEM
The kettle and indicator
light do not work when the
power switch is turned on.
The water is boiling, but the
power switch and indicator
light are still on.
The kettle will not turn on.
There are mineral deposits
inside the kettle.
SOLUTION
Make sure that your kettle is seated properly on the base and that
the base is connected to a functioning electrical outlet.
The auto-shut o function does not operate properly if the lid is
not completely closed. Let the kettle cool, then make sure that
the lid is properly locked into place.
• Make sure that the kettle is seated properly on the base and
that the base is connected to a functioning power outlet.
• Water or debris on the bottom of your kettle or on the base
may interfere with the functioning of your kettle. Make sure
that the bottom of your kettle and the base are dry and free of
debris.
• A certain amount of scale build-up is normal after long periods
of use and is caused by minerals contained in hard water. The
best way to prevent mineral deposits is to always use distilled
water in the kettle.
• To remove deposits, try lling your kettle with water and a few
slices of lemon, then boil. If this does not work, see “Removing
mineral deposits.”
Additional safety concerns
1 Before connecting your kettle to the power outlet, make sure that the voltage indicated on the bottom of
your kettle and base corresponds with the voltage in your home. If this is not the case, contact your
dealer and do not use your kettle.
2 The attached base must not be used for any purpose other than its intended use.
3 Even though boil-dry protection is built into your kettle, we recommend that you do not operate your
kettle without water to avoid damaging the heat elements.
4 If you try to operate your kettle without water, the boil-dry protection automatically switches it o. If this
should occur, let your kettle cool before lling it with cold water.
5 To prevent injury or damage from an overturned kettle, make sure that your kettle is used on a rm and
at surface where children cannot touch it.
6 Always make sure that you pour boiling water slowly and carefully without tipping your kettle too fast.
7 Be careful when opening the lid for relling if your kettle is hot.
8 Use the handle to avoid touching the hot surface of your kettle.
9 Use extreme caution when moving your kettle if it contains hot water.
10 Your kettle is not a toy. Do not let the children play with it.
11 Avoid contacting steam from the spout when water is boiling or just after your kettle has switched o. Do
not remove the lid too soon.
12 Unplug your kettle from the power outlet when not in use and before cleaning. Let it cool before putting
on or taking o parts and before cleaning your kettle.
13 Always make sure that the lid is closed and that you do not lift it while the water is boiling. Scalding may
occur if the lid is removed during use.
14 Do not move your kettle while it is on.
15 Only use your kettle with the provided base.
16 If your kettle is overlled, boiling water may be ejected.
17 Your kettle is intended to be used in household and similar environments.
SAVE THESE INSTRUCTIONS
ONEYEAR LIMITED WARRANTY
Visit www.insigniaproducts.com for details.
CONTACT INSIGNIA
For customer support, call 1-877-467-4289 (U.S. and Canada) or 01-800-926-3000 (Mexico)
www.insigniaproducts.com
INSIGNIA is a trademark of Best Buy and its aliated companies.
Distributed by Best Buy Purchasing, LLC
7601 Penn Ave South, Richeld, MN 55423 U.S.A.
©2019 Best Buy. All rights reserved.
Made in China
  • Page 1 1
  • Page 2 2

Insignia NS-EK17BK9 Quick setup guide

Insignia
Brand
Insignia
Model
NS-EK17BK9
Category
Electric kettles
Type
Quick setup guide
Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Related papers

Other documents