QI-HT377-WM-E-050405
REDWHITE
RED
WHITE
WHITE
RED
WHITE
WHITE
RED
GREEN
RED
SPEAKERS
OR
OR
OR
QUICK INSTRUCTIONS
1
MODEL HT-377
A. PREPARATION
1.Battery installation
REMOTE control requires 2 size “AAA” alkaline batteries (included).
Insert batteries as shown.
2.Remote control operating range
Point the REMOTE CONTROL (within 20 feet) at the HOME THEATER
SYSTEM [SUBWOOFER] (not your TV set or DVD player).
3.System Connections
Connect the supplied speaker system by matching the colors of the terminals to those of the cords.
IMPORTANT: Before making connections, make sure the power is off.
IMPORTANT NOTE FOR
DVD USE: This Home Theater
system only improve the
sound of your DVD player; for
your DVD’s video output,
connect the video output jack
to your TV’s video input jack.
NOTE: In order to have TV sound come through your home theater system, your TV must have AUDIO OUTPUT jacks. These jacks will
always be in the rear of the TV (and not in the front). If your TV does not have these output jacks, you have to use a cable box or a satellite
receiver to get the audio.
QUICK SETUP DIAGRAM
Remember to flip the main
switch to the on position.
QI-HT377-WM-E-050405
ON/STANDBY
MUTE
SOURCE
ON
STANDBY
VOL
VOL
SOURCE
DVD
MP3
+
QUICK INSTRUCTIONS
2
REMOTE CONTROL
CONTROL PANEL
(ON THE FRONT OF THE SUBWOOFER)
1Make sure the POWERswitch on the back of the main set is at “ON” position. Next press the ON/STANDBY button on the
front of the main set or on the REMOTE CONTROL to turn the set on (or standby).
NOTE: The STANDBY indicator has 2 modes: flashing and steadily on (slow flashing indicates the set is in standby
mode, steadily on indicates the set is on). When the set is on, pressing the ON/STANDBY button on the main set
or on the REMOTE CONTROL will turn the set to the standby mode, the indicator will become slow flashing.
2Press the SOURCE button on the front panel of the main set or on the REMOTE CONTROL to select one of the audio input
sources, the corresponding indicator will light, the factory’s default input source is DVD, when the set is turned on, the
DVD indicator will be on.
3For volume adjustments, press the volume control buttons on the Remote control, the ON/STANDBY indicator will flashs
to show you that the remote signal is received .
4To momentarily shut off the sound, press the MUTE button. The source indicator (DVD or MP3) will flash. Press the MUTE
button again or press the VOLUME buttons to restore the sound.
NOTE: Flip the POWER switch on the back of the main set to “OFF” if the set will not be used for a long period of
time (several days or more).
ON/STANDBY
button
MUTE button
SOURCE
button
VOLUME -
button
VOLUME +
button
ON/STANDBY
button
ON/STANDBY
indicator
VOLUME +
button
VOLUME -
button
SOURCE
button
DVD
indicator
MP3 indicator
NOTE: Every time you turn the set on, the VOLUME will go back to the factory’s default setting; and whenever you
press the SOURCE button on the main unit or on the REMOTE, the VOLUME will go back to the factory’s default
setting. This avoids sudden very loud sounds from startling you.
B. BASIC PLAY
/
