1
Installation Instructions for
Secure the mounting plate to the junction box.
Connect the fixture ground wire to a suitable ground in accordance to local electrical codes.
Connect the white fixture wire to the neutral power line wire with a wire nut.
Connect the black fixture wire to the hot power line wire with a wire nut.
Mount the fixture onto the mounting plate and secure it in place with the fixture screws.
Install the shade and spacer by placing them over the socket, then secure them in place by screwing the collar nut onto the
socket.
Screw the lamp into the socket. Refer to the label on the socket for Max Wattage Information. Repeat steps 6 and 7 for
remaining sockets.
1
2
3
4
5
Sutton Wall
1.0
VS24321-VS24322-VS24323-VS24324-L1
VS24321, VS24322, VS24323, VS24324
Wall
CAUTION RISK OF FIRE-
This product must be installed in accordance with the
applicable installation code by a person familiar with the
construction and operation of the product and the hazards
involved.
Use minimum 90°c supply conductors.
6
7
GP I :ENERAL RODUCT NFORMATION
These fixtures are intended to be installed utilizing compliant junctionNEC
boxes.
This product is safety listed for damp locations.
Incandescent lamps may be dimmed with a standard incandescent dimmer.
LED LEDlamps may be dimmed with a dimmer. Consult lamp manufacturer for
additional information.
1A
JUNCTION BOX
MOUNTING
PLATE
3
4
LAMP
COLLAR NUT
5
FIXTURE
SCREW
5
7
SPACER
SHADE
SOCKET
6
SHADE BASE
Page is loading ...
Page is loading ...
SAVETHESE INSTRUCTIONS!
4
7400 Linder Ave, Skokie, 60077IL
800.969.3347
www.Feiss.com
© 2018 Feiss.All rights reserved.The "Feiss" graphic is a
registered trademark of Feiss. Feiss reserves the right to
change specifications for product improvements without notification.
A Generation Brands Company
/
