27 cu. ft. Side-by-Side
MODEL RS27T5200 DIMENSIONS
Be sure your new fridge will fit
Don't wait until delivery to be sure your new refrigerator will t – both
in your kitchen and through all doorways. This guide includes all pertinent
measurements and clearances so you can buy with condence.
Standard-Depth Refrigerator
Standard-depth refrigerators typically measure 30 to 35 inches in depth,
as opposed to counter-depth refrigerators that sit ush with cabinetry.
Measure height
including flooring.
Be sure to allow for
hinge clearance
height if needed.
Measure width
including countertop
overhang.
Measure depth
including molding
or trim.
Walk the delivery route
3Identify the narrowest opening that the appliance will travel, from outside the home to the location where it will be installed.
3Appliance depth or width must be smaller than the width of the narrowest opening.
Installation clearances
3Allow 3.75" of clearance when installing along a wall.
This will allow for the door to open 90 degrees without
the handle contacting the wall.
3Allow 2" minimum clearance at rear for proper air
circulation and water/electrical connections.
3Allow a 3/8" minimum clearance at sides and top
for ease of installation.
For optimal usage and ability to open refrigerator doors
completely, do not install next to a wall.
Please note: The above dimension and cutout information is for planning
purposes only. For complete installation details, consult manual packed
with product, or download manual online at samsung.com.
DEPTH
WITHOUT
DOOR
28
15
/
16
"
WIDTH
(FITS 36" OPENING)
35
7
/
8
"
HEIGHT
WITH
HINGE
70
1
/
16
"
DEPTH
WITHOUT
HANDLE
33
1
/
2
"
DEPTH
WITH D00R
OPEN 90°
51
5
/
16
"
TOP OF REFRIGERATOR WITH DOORS OPEN 90°
68
1
/
4
"
165° 170°
TOP OF REFRIGERATOR WITH DOORS OPEN
165° (FREEZER DOOR)
170° (REFRIGERATOR DOOR)
