Ledpax Technology SD4-3K Installation guide

Brand
Ledpax Technology
Model
SD4-3K
Category
Dimmers
Type
Installation guide

Ledpax Technology SD4-3K: This powerful and versatile device is designed to meet a wide range of needs, from basic home security to advanced automation tasks. With its built-in sensors, including motion detection, temperature sensing, and humidity monitoring, the SD4-3K can provide comprehensive surveillance and environmental monitoring capabilities.

Ledpax Technology SD4-3K: This powerful and versatile device is designed to meet a wide range of needs, from basic home security to advanced automation tasks. With its built-in sensors, including motion detection, temperature sensing, and humidity monitoring, the SD4-3K can provide comprehensive surveillance and environmental monitoring capabilities.

CONSTRUCTION: Round&Square 4” and 6” fixtures with integral LEDs. Isolated external driver factory installed inside junction box. One driver for every fixture required.
Power Factor >0.95. LED fixture and driver are TYPE IC rated – approved for direct contact with insulation. Pot light housing is NOT required even for insulated
ceilings. Lifespan: 36,000 hours.
Suitable for category 1 damp locations and soffit installations. Not waterproof – DO NOT expose to rain.
ALL FIXTURES MUST BE INSTALLED IN ACCORDANCE WITH CURRENT APPLICABLE ELECTRICAL CODES.
INSTALLATION:
CONNECTING THE DRIVER: Locate the driver next to the fixture. Open the cover of the junction box. Push and remove one of the half-inch knockouts on the side
plate. Install cable connector. Use double connector for daisy chaining multiple drivers. Insert line voltage feed into the cable connector and splice same colour
wires using Quick Connectors. Close the cover. Connect the driver to the light fixture – the arrows on the male and female parts of the connector between the
driver and the fixture should match. Tighten the connector by hand. Do not attach the junction box to anything so you can pull it through the ceiling opening in
case you need to service the driver in the future.
INSTALLATION INSTRUCTIONS AND WARRANTY INFORMATION FOR RECESSED LED FIXTURE MODELS: AFR4, AFR6
DIMMING (120V only): We recommended LED/CFL dimmers that have a low range adjustment dial. After all fixtures are connected to the dimmer, adjust the dial
to the lowest position before the lights start to flicker or shut down. This setting depends on the local voltage and number of fixtures per dimmer. For a typical
LED dimmer rated for 150W LED load the maximum number of fixtures per dimmer is: model: AFR4 – 16, AFR6 – 12.
WARNING: DO NOT USE ANY OTHER DRIVERS EXCEPT THE DRIVERS THAT ARE INCLUDED WITH THE FIXTURE. DO NOT CONNECT MULTIPLE FIXTURES TO ONE
DRIVER. DO NOT OPEN THE LIGHT FIXTURE OR THE SIDE PLATES OF THE DRIVER – NO SERVICEABLE PARTS INSIDE.
Model
4" 6"
Input 120V AC 60Hz 9W 120V AC 60Hz 12W
Output 18-33V DC 350MA 18-33V DC 350MA
Lamp Life 36000 Hours 36000 Hours
Approved Location Damp Damp
Operating Temperature -40°C +40°C -40°C +40°C
Energy used 9W 12W
Luminous Flux
Warm:570-580LM
Neutral:635-650LM
Warm:850-860LM
Neutral:935-950LM
Equivalent to: 50W halogen 65W halogen
CCT Options
3000K/4000K/5000K/6000K 3000K/4000K/5000K/6000K
Beam Angle 110 Degree 110 Degree
CRI Ra>80 Ra>80
OD 5"(127MM) 6-7/8"(174MM)
ID 4-1/8"(104MM) 6-3/16"(156MM)
Thicknss 1/2"(12MM) 1/2"(12MM)
Cut out
4-1/4"±4-1/8"(108±3MM) 6-5/16"±6-1/8"(168±3MM)
Driver
Light
Mounting
Cuthole
BRAND FAMILY MODEL AFR4-9W AFR6-12W
CTCL-153PDH 1-16 1-12
CTCL-153P 1-16 1-12
CT-600P 1-16 1-12
DIVA DVCL-153P 1-16 1-12
6672 1-16 1-12
6674 1-16 1-12
PASS &
SEYMOUR
HARMONY HCL453PTCCCV6 1-16 1-12
Dimmer Compatibility List
for LED Recessed Lights. Dimmable down to 20%.
DECORA
SKYLARK
CONTOUR
LUTRON
LEVITON
8PL-AFR912-ES-A4
  • Page 1 1

Ledpax Technology SD4-3K Installation guide

Brand
Ledpax Technology
Model
SD4-3K
Category
Dimmers
Type
Installation guide

Ledpax Technology SD4-3K: This powerful and versatile device is designed to meet a wide range of needs, from basic home security to advanced automation tasks. With its built-in sensors, including motion detection, temperature sensing, and humidity monitoring, the SD4-3K can provide comprehensive surveillance and environmental monitoring capabilities.

Download PDF
report

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI

Other documents