Aspen Snow Cool AR1-N Installation guide

Aspen Snow Cool

Aspen Snow CoolAspen Snow Cool

Aspen Snow Cool

Rigid Media

Rigid MediaRigid Media

Rigid Media

WARNING: To avoid electrical shock, disconnect power to your cooler before

installing or servicing the pad.

NOTE: Aspen Snow Cool Rigid Media is constructed with two differing angles

for water and airflow.

INSTALL ONLY AS SHOWN IN DIAGRAM.

The Aspen Snow Cool Rigid Media is made up of alternating sheets with two

different angles. When the media is installed properly, the 45° angle slopes

down toward the air entering side of the media as shown in the diagram. Failure

to install media properly may lead to reduced performance and water carry-over

into the dry section of the cooler.

NOTE: There may be a slight odor noticed during the initial start-up following

installation of this pad. The odor will disappear within the first few days of

operation if bleed-off is used.

This manual is also suitable for

Download PDF