SENMAL LOCH4440 User manual

Hello! I've reviewed the instructions for the Mini Mill LOCH4440. This document provides a clear step-by-step guide to assembling your mill and ensuring proper alignment. It covers attaching the V rail, adjusting the handle, and clamping the saw bar square. I'm ready to answer any questions you may have about using the mini mill.
What is the purpose of the oblong holes on the outrigger skid?

What should I do after setting the mill assembly on the guide board?

What is the final step in the assembly process?

Mini Mill Instructions

Note: outrigger skid has oblong holes for squaring mill with saw bar

1 .Attach V rail to guide board 2.Set mill assembly on guide board

and loosen both large nuts attaching

outrigger skid

3.Remove smaller nut and bolt

that attaches handle to skid.

4.Tilt up handle and insert smaller

bolt and attach washer and loosely

tighten small nut

5.Push down equally on mill

assembly body and outrigger skid.

Then tighten both large nuts.

6.Tighten smaller nut that secures

the end of the handle. Mill should

now sit flat on guide board. Saw bar

will now clamp square. Slight

adjustments can be made if saw

does not cut square.(Chainsaw not

included)