2. BLOTZ
  3. B28-RU-011

BLOTZ B28-RU-011 Assembly Instructions

  • Hello! I am a chat assistant and I have reviewed the provided instructions for the 28mm Ruined Archway model B28-RU-011. The document details how to assemble the archway using PVA glue, a modelling knife, and suggests using pegs or elastic bands while the glue dries. I'm ready to answer any questions you have about assembling this model.
  • What type of glue is recommended for assembly?
    What tool is needed to remove parts from the sprue?
    What can be used to hold pieces in place while drying?
28mm Ruined Archway
B28-RU-011
Please read these instructions fully before starting construction.
PVA or equivalent glue will be required to stick sections together.
Sand paper can be used to gently clean any joints.
A sharp modelling knife will be required to remove sections from the sprue. Please use knives with due care and remember
to cut away from yourself at all times.
During the construction of this model, you may find it convenient to use pegs / elastic bands to hold pieces in place while
you allow glue to dry.
Remove the base, front and short wall from the sprue
(as shown above).
Attach the short wall to the front wall, then glue the
pair of them to the base as shown.
Glue the back wall into place, followed by the other
side of the short wall.
/