Chief TA300 Installation guide

Brand: Chief

Model: TA300

Category: Wall & ceiling mounts accessories

Type: Installation guide

INSTALLATION INSTRUCTIONS

Instrucciones de instalación

Installationsanleitung

Instruções de Instalação

Istruzioni di installazione

Installatie-instructies

Instructions d´installation

Side Speaker Bracket

Spanish Product Description

German Product Description

Portuguese Product Description

Italian Product Description

Dutch Product Description

French Product Description

TA300

TA300 Installation Instructions

DISCLAIMER

Milestone AV Technologies and its affiliated corporations and

subsidiaries (collectively "Milestone"), intend to make this

manual accurate and complete. However, Milestone makes no

claim that the information contained herein covers all details,

conditions or variations, nor does it provide for every possible

contingency in connection with the installation or use of this

product. The information contained in this document is subject

to change without notice or obligation of any kind. Milestone

makes no representation of warranty, expressed or implied,

regarding the information contained herein. Milestone assumes

no responsibility for accuracy, completeness or sufficiency of

the information contained in this document.

Chief® is a registered trademark of Milestone AV Technologies.

IMPORTANT WARNINGS AND

CAUTIONS!

WARNING: A WARNING alerts you to the possibility of

serious injury or death if you do not follow the instructions.

CAUTION: A CAUTION alerts you to the possibility of

damage or destruction of equipment if you do not follow the

corresponding instructions.

WARNING: Failure to read, thoroughly understand, and

follow all instructions can result in serious personal injury,

damage to equipment, or voiding of factory warranty! It is the

installer’s responsibility to make sure all components are

properly assembled and installed using the instructions

provided.

WARNING: Failure to provide adequate structural strength

for this component can result in serious personal injury or

damage to equipment! It is the installer’s responsibility to

make sure the structure to which this component is attached

can support five times the combined weight of all equipment.

Reinforce the structure as required before installing the

component.

WARNING: Exceeding the weight capacity can result in

serious personal injury or damage to equipment! It is the

installer’s responsibility to make sure the combined weight of

all equipment and accessories mounted on the TA300

bracket does not exceed 20 lbs (9.08 kg) or 10 lbs (4.54 kg)

per speaker.

DIMENSIONS

MAXIMUM EXTENSION

68.1

2.68

1570.9

61.8

59.165

1502.8

7.1

.280

485.4

19.1

425.2

16.7

472.2

18.6 410.1

16.15

.40

10.2

3.4

TO MOUNT

.13

DEPTH ADDED

.81

20.6

.68

17.2

MINIMUM EXTENSION

41.3

1.625

36.942

938.3

20.6

.813

Installation Instructions TA300

LEGEND

Tighten Fastener

Apretar elemento de fijación

Befestigungsteil festziehen

Apertar fixador

Serrare il fissaggio

Bevestiging vastdraaien

Serrez les fixations

Loosen Fastener

Aflojar elemento de fijación

Befestigungsteil lösen

Desapertar fixador

Allentare il fissaggio

Bevestiging losdraaien

Desserrez les fixations

Phillips Screwdriver

Destornillador Phillips

Kreuzschlitzschraubendreher

Chave de fendas Phillips

Cacciavite a stella

Kruiskopschroevendraaier

Tournevis à pointe cruciforme

Open-Ended Wrench

Llave de boca

Gabelschlüssel

Chave de bocas

Chiave a punte aperte

Steeksleutel

Clé à fourche

By Hand

A mano

Von Hand

Com a mão

A mano

Met de hand

À la main

Hex-Head Wrench

Llave de cabeza hexagonal

Sechskantschlüssel

Chave de cabeça sextavada

Chiave esagonale

Zeskantsleutel

Clé à tête hexagonale

Pencil Mark

Marcar con lápiz

Stiftmarkierung

Marcar com lápis

Segno a matita

Potloodmerkteken

Marquage au crayon

Drill Hole

Perforar

Bohrloch

Fazer furo

Praticare un foro

Gat boren

Percez un trou

Adjust

Ajustar

Einstellen

Ajustar

Regolare

Afstellen

Ajuster

Remove

Quitar

Entfernen

Remover

Rimuovere

Verwijderen

Retirez

Optional

Opcional

Optional

Opcional

Opzionale

Optie

En option

Security Wrench

Llave de seguridad

Sicherheitsschlüssel

Chave de segurança

Chiave di sicurezza

Veiligheidssleutel

Clé de sécurité

TA300 Installation Instructions

TOOLS REQUIRED FOR INSTALLATION

PARTS

5/32" (included)

1/8" (included)

3/8"

A (2)

B (2)

C (2)

[attachment bracket]

D (8) E (8)

#10-24 x 3/8"

5/32" 1/8"

K (1) L (1)

[speaker bracket]

F (4)

#10-24 x 1/4" G (4) H (8)

[horizontal bracket]

#10-24 x 1/2" #10 #10-24

J (8)

#10-24 x 1/2"

Installation Instructions TA300

Installation

Install Attachment Brackets to Faceplate

TS525 or iCF50 Installation

NOTE: Display does NOT have to be removed to attach

brackets to TS525TU or iCF50 faceplate.

IMPORTANT ! : If also installing center channel speaker

bracket (TA350) or another accessory above or below

display, install that bracket at this point instead of the

respective attachment bracket (B). The attachment

bracket will not be used in these cases as the accessory

brackets will connect directly to the horizontal brackets

(A). See corresponding installation instructions for

details.

1. Use four #10-24 x 1/4" button head cap screws (E) to

connect attachment bracket (B) to upper holes on swing

arm faceplate. (See Figure 1)

Figure 1

2. Use four #10-24 x 1/4" button head cap screws (E) to

connect second attachment bracket (B) to lower holes on

swing arm faceplate. (See Figure 2)

Figure 2

3. Proceed to Speaker Bracket Installation Section.

TS3XX or iCF30 Installation

IMPORTANT ! : If also installing center channel speaker

bracket (TA350) or another accessory above or below

display, install that bracket at this point instead of the

respective attachment bracket (B). The attachment

bracket will not be used in these cases as the accessory

brackets will connect directly to the horizontal brackets

(A). See corresponding installation instructions for

details.

1. If already installed, remove display from faceplate. See

swing arm installation instructions for details.

2. Use four #10-24 x 1/2" Phillips flat head cap screws (J) and

four #10-24 lock nuts (H) to connect attachment bracket (B)

to upper holes on faceplate. (See Figure 3)

Figure 3

3. Use four #10-24 x 1/2" Phillips flat head cap screws (J) and

four #10-24 lock nuts (H) to connect second attachment

bracket (B) to lower holes on faceplate. (See Figure 4)

Figure 4

4. Install display to faceplate. See swing arm installation

instructions for details.

(display not shown for clarity)

(B)

(E) x 4

(display not shown for clarity)

(B)

(E) x 4

(B)

(H) x 4

(J) x 4

(B)

(H) x 4

(J) x 4

TA300 Installation Instructions

Speaker Bracket Installation

1. Use four #10-24 x 3/8" Phillips machine screws (D) to

connect one speaker bracket (C) to upper and lower

horizontal brackets (A). (See Figure 5)

Figure 5

2. Slide connected horizontal brackets (A) and speaker

bracket (C) onto back of display until center two holes on top

horizontal bracket are aligned with two slots on top of

attachment bracket (B). (See Figure 6)

Figure 6

3. Use two #10-24 x 1/2" button head cap screws (F) and two

#10 washers (G) to connect top horizontal bracket (A) to

attachment bracket (B). (See Figure 7)

Figure 7

4. If necessary, extend arms beyond edge of display by

loosening (not removing) extension adjustment screws on

horizontal brackets and extending arms. Tighten

adjustment screws when desired position is reached. (See

Figure 8)

5. Use four #10-24 x 3/8" Phillips machine screws (D) to

connect second speaker bracket (C) to upper and lower

horizontal brackets (A). (See Figure 8)

Figure 8

(A) x 2

(D) x 4

(C)

(F) x 2

(G) x 2

(B)

extension adjustment

screw

(D) x 4

Installation Instructions TA300

6. Use two #10-24 x 1/2" button head cap screws (F) and two

#10 washers (G) to connect lower horizontal bracket (A) to

either attachment bracket (B), TA350 bracket (if also using

center channel) or other accessory bracket. See

corresponding installation instructions for details if another

bracket is being installed. (See Figure 9)

Figure 9

7. Attach speakers to speaker brackets (C) appropriate

hardware (not provided). Adjust extension of horizontal

brackets as needed. (See Figure 10)

WARNING: Exceeding the weight capacity can result in

serious personal injury or damage to equipment! It is the

installer’s responsibility to make sure the combined weight of

all equipment and accessories mounted on the TA300

bracket does not exceed 20 lbs (9.08 kg) or 10 lbs (4.54 kg)

per speaker.

Figure 10

Adjustments

Extension Adjustment

1. Loosen four extension adjustment screws on horizontal

brackets. (See Figure 11)

2. Adjust speaker brackets to desired horizontal positions.

(See Figure 11)

3. Tighten four extension adjustment screws when desired

mounting position is reached. (See Figure 11)

Figure 11

(F) x 2

(G) x 2

(B)

speakers (example)

1 3

TA300 Installation Instructions

USA/International A 8401 Eagle Creek Parkway, Savage, MN 55378

P800.582.6480 / 952.894.6280

F877.894.6918 / 952.894.6918

Europe A Fellenoord 130 5611 ZB EINDHOVEN, The Netherlands

P+31 (0)40 2668620

F+31 (0)40 2668615

Asia Pacific A Office No. 1 on 12/F, Shatin Galleria

18-24 Shan Mei Street

Fotan, Shatin, Hong Kong

P852 2145 4099

F852 2145 4477

Chief Manufacturing, a products division

of Milestone AV Technologies

8805-002021 Rev01

2011 Milestone AV Technologies, a

Duchossois Group Company

www.chiefmfg.com

08/11

Chief TA300 Installation guide

Brand: Chief

Model: TA300

Category: Wall & ceiling mounts accessories

Type: Installation guide

Download PDF

report

in other languages

français: Chief TA300 Guide d'installation

Chief TA300 Installation guide

Chief TA300 Installation guide

in other languages

Related papers

Other documents