2. Computers & electronics
  3. TVs & monitors
  4. Wall & ceiling mounts accessories
  5. Peerless
  6. ACC328

Peerless ACC328 Owner's manual

  • Hello! I've read the installation and assembly instructions for the Peerless Laptop Shelf ACC328. This document includes detailed steps on how to attach the edging and mount the shelf, along with a parts list and compatibility information. I'm ready to answer questions you may have about the process.
  • What is the maximum load capacity per arm for this laptop shelf?
    What models is this laptop shelf compatible with?
    What type of screws are used to secure the laptop shelf to the arm plate?
3215 W. North Ave. • Melrose Park, IL 60160 • (800) 729-0307 or (708) 865-8870 • Fax: (708) 865-2941 • www.peerlessmounts.com
ISSUED: 10-08-09 SHEET #: 120-9071-2 11-05-09
Max Load Capacity per Arm: 17.5 lb (8 kg)
Installation and Assembly:
Laptop Shelf
Model: ACC328
NOTE: Read entire instruction sheet before you start installation and assembly.
For customer care call (800) 865-2112 or (708) 865-8870.
Parts may appear slightly different than illustrated.
Before you begin, make sure all parts shown are included with your product.
A
Parts List
Description Qty. Part Numbe
r
A
laptop shelf 1 021-1040
Bplastic cover 1 600-0120
Cplastic edging 1 600-0121
D3" rubber edging 2 600-0122
Ewasher 8 540-1001
FM4 x 16 mm screw 4 520-1119
GM4 nylock nu
t
4 530-1055
G
F
E
D
C
B
Compatible with models (sold separately):
LCT-A1B1C, LCT-A1B1H, LCT-A1B4C, LCT-A1B4H
ISSUED: 10-08-09 SHEET #: 120-9071-2 11-05-09
Visit the Peerless Web Site at www.peerlessmounts.com
2 of 2
1
Attaching Edging to Laptop Shelf
FIGURE 2.1
FIGURE 2.2
A
F
G
E
E
ARM PLATE
A
ARM PLATE
B
FIGURE 1.1
Remove protective backing from plastic cover (B). Adhere plastic cover (B) to the arm plate of the desktop mount
(sold separately) while keeping the holes aligned as shown in gure 2.1. Slide laptop shelf (A) down, over the back
of the arm plate as shown in gure 2.1. Secure laptop shelf to arm plate with four screws (F), eight washers (E)
and four nylock nuts (G) as shown in gure 2.2.
Attach rubber edging (D) to laptop shelf (A) as shown in gure 1.1. Attach plastic edging (C) to laptop shelf as
shown in gure 1.2. NOTE: Plastic edge (C) may already be attached.
CFIGURE 1.2
D
2
Attaching Laptop Shelf to Arm Plate
Make sure
holes are
aligned
A
© 2009, Peerless Industries, Inc. All rights reserved.
All other brand and product names are trademarks or registered trademarks of their respective owners.
Peerless Industries, Inc.
3215 W. North Ave.
Melrose Park, IL 60160
www.peerlessmounts.com
• Desktop mount arm springs under tension. Must
adjust to weight of laptop.
WARNING
/