FLASH F7100768 User manual

Brand: FLASH

Model: F7100768

Category: Stroboscopes & disco lights

Type: User manual

FLASH F7100768 is a professional LED moving head with powerful features, such as 19x15W 4-in-1 LEDs, a wide zoom range of 4° to 60°, and various control options for versatile use in stage lighting.

LED MOVING HEAD

19x15W BIG EYE

SERIES: DJ

User Manual

Art No F7100768

(ver.05.23)

EAN 5905358808481

21/35/78/97/112 CH

CONTENTS

INTRODUCTION 3

SAFETY INFORMATION 3

PRODUCT INFORMATION 4

INSTALLATION 4

CONNECTION 6

DMX CHART 8

PHOTOMETRICS 10

WARNING! The Led Moving Head (LMH) has a powerful pan and lt mo-

tor. The torque reacon when the head is panned suddenly can cause the

base to move if the xture is standing unsecured on a surface. Do not apply

power to the LMH unless the baase is securely fastened to a surface or to

rigging hardware.

WARNING! Use 2 clamps to rig the xture. Do not hang the xture from

only one clamp. Lock each clamp with both 1/4-turn fasteners. Fasteners

are locked only when turned a full 900 clockwise.

WARNING! When clamping the xture to a truss or other structure at

any other angle than with the yoke hanging vercally downwards, use two

clamps of half-coupler type. Do not use any type of clamp that does not

completely encircle the structure when fastened.

WARNING! Posion or shade the head so that the front lens will not be

exposed to sunlight or any other strong light source from any angle - even

for a few seconds. See Figure 1. The LMH lens can focused the sun’s rays,

creang a potenal re hazard and causing damage.

IMPORTANT! Do not point strong light output from other xtures at the

LMH, as intense illuminaon can damaged the display.

Figure 1.

INTRODUCTION

SAFETY INFORMATION

THANK YOU FOR PURCHASING 19x15W BIG EYE. FOR SAFETY

REASONS AND TO ENSURE THE TROUBLE-FREE OPERATION, CA-

REFULLY READ THE INSTRUCTIONS.

Please keep this User Manual

for future consultaon. If you sell

the xture to another user, be sure

that they also receive this instruc-

on booklet.

Unpack and check carefully the-

re is no transportaon damage be-

fore using the xture.

Before operang, ensure that

the voltage and frequency of po-

wer supply match the power

requirements of the xture.

It’s important to ground the

yellow/green conductor to earth

in order to avoid electric shock.

Disconnect main power before

servicing and maintenance.

Use safety chain when xes this

xture. Don’t handle the xture by

taking its head only, but always by

taking its base.

Maximum ambient temperature

is: 40°C Don’t operate it where the

temperature is higher than this.

In the event of serious ope-

rating problem, stop using the

fixture immediately. Never try

to repair the fixture by your-

self.

Repairs carried out by unskil-

led people can lead to damage

or malfunction. Please contact

the nearest authorized techni-

cal assistance center. Always

use the same type spare parts.

Do not connect the device

to any dimmer pack.

Do not touch any wire during

operation and there might be a

hazard of electric shock.

To prevent or reduce the risk

of electrical shock or fire, do

not expose the fixture to rain

or moisture.

The housing must be repla-

ced if they are visibly damaged.

Do not look directly at the li-

ght spot while the fixture is on.

In the latest version of this Head, the colors in the macro channel have been

improved, making them more natural and consistent with the paern. The co-

lors on the dimmers, power and parameters remain the same as in the previous

version (F7100547).

PRODUCT INFORMATION

INSTALATION

Light Source:

19 pcs x 15W 4in1 LEDs

Power consumpon: 300W

Power supply voltage:

110-245V, 50/60Hz AC

PAN range: 540°

TILT range: 270°

Beam angle (min/max): 4°-60°

Color: RGBW

Zoom: Yes

LED outline stripe eect

Operang modes: DMX 512,

Auto-running, Master/Salve,

Sound acve

DMX channel mode

21/35/78/78/97/112

IP Rang: IP65

Housing made: ABS

Integrated fastening hooks

Cooling: Acve

AC IN/OUT: PowerCon

3-Pin XLR DMX Input/Output

Net Weight: 14.4 kg

Weight with packaging:

59 kg (2x MH+Case)

Dimensions:

H(48)xW(40)xD(26) cm

Dim. (case):

H(59)xW(74)xD(46) cm

The unit should be mounted via its screw holes on the bracket. Always

ensure that the unit is rmly xed to avoid vibraon and slipping while

operang. Always ensure that the structure to which you are aaching

the unit is secure and is able to support a weight of 10 mes of the

unit’s weight. Also always use a safety cable that can hold 12 mes of

the weight of the unit when installing the xture. The equipment must

be xed by professionals. And it must be xed at a place where is out of

the touch of people and has no one pass by or under it.

The following item

are included inside the case:

❶ - Moving Head (2pcs)

❷ - powerCON cable (2pcs)

❸ - Omega clamp (4pcs)

❹ - User manual (1pc)

❺ - Transport Case

F7100767 [EAN 5905358808474]:

2x Moving Heads 19x15W Big Eye SET ver.05.23 + Case (SET)

AVAILABLE VERSIONS:

The following item

are included inside the box:

❶ - Moving Head (1pc)

❷ - powerCON cable (1pc)

❸ - Omega clamp (2pcs)

❹ - User manual (1pc)

❶

❷

❸

❹

❺

User

Manual

User

Manual

F7100768 [EAN 5905358808481]:

1x Moving Head 19x15W Big Eye SET ver.05.23 (carton package)

CONNECTION

The device is equipped with the following interfaces:

1. DMX (in/out): XLR 3(5)-pin socket

2. Power (in/out): powerCON socket

The connecon is performed using cable with

XLR-female -> XLR-Male plugs.

SHIELD

SIGNAL (+)

SIGNAL (-)

FEMALE

XLR

MALE

XLR

SHIELD

SIGNAL (+)

SIGNAL (-)

FEMALE

XLR

MALE

XLR

CAUTION! At the last xture, the

DMX signal has to be terminated

with a terminator. Solder a 120Ω

resistor between signal (-) and si-

gnal (+) into a XLR plug and plug

it in the DMX output of the last

xture.

3-PIN XLR

5-PIN XLR

Diagram of connecon of devices by DMX cable.

IMPORTANT! The maximum number of devices connected

in series via power cable is 6 pcs.

DMX

Controller DMX 512 DMX 512 120

Using lamp, the change rate of power voltage should be within ±10%,

if the voltage is too high, it will shorten the light’s life; if it’s not enough,

the lamp will be dark. Please restart it aer turning o light for 20 mi-

nutes unl full-cooling. Frequent switching will reduce the life span of

lamps and bulbs; intermient using will improve the life of bulbs and

lamps.

Input Voltage Frequency Total Power

100-245[V] AC 50/60[Hz] 300[W]

Voltage Specycaon.

The connecon is performed using power cable with powerCON

TRUE1 connector (included). The device must be operated by qualied

personnel.

CAUTION! In the case of cable damage do not aempt to repair. Repla-

cement or repair can be made only on the manufacturer or by a person

with appropriate permissions

DMX CHART

21 CH 35 CH

CHANNEL MODE

1Red

2Red ne

3 Green

4Green ne

5 Blue

6Blue ne

7 White

8White ne

9 Linear CTO

10 Macro colour

11 Strobe

12 Dimmer

13 Dimmer Fine

14 Pan

15 Pan Fine

16 Tilt

17 Tilt Fine

18 Funcon

19 Reset

20 Zoom

21 Zoom Rotaon

CHANNEL MODE

1Red

2Red ne

3 Green

4Green ne

5 Blue

6Blue ne

7 White

8White ne

9 Linear CTO

10 Macro colour

11 Strobe

12 Dimmer

13 Dimmer Fine

14 Pan

15 Pan Fine

16 Tilt

17 Tilt Fine

18 Funcon

19 Reset

20 Zoom

21 Zoom Rotaon

22 Shape Selecon

23 Shape Speed

24 Shape Fade

25 Shape R

26 Shape G

27 Shape B

28 Shape W

29 Shape Dimmer

30 Background Dimmer

31 Shape Transion

32 Shape Oset

33 Foreground Strobe

34 Background Strobe

35 Background Select

CHANNEL MODE

1 Red LED 1

2 Green LED 1

3 Blue LED 1

… Red LED …

… Green LED …

… Blue LED …

55 Red LED 19

56 Green LED 19

57 Blue LED 19

CHANNEL MODE

1 Red LED 1

2 Green LED 1

3 Blue LED 1

4 White LED 1

… Red LED …

… Green LED …

… Blue LED …

… White LED …

73 Red LED 19

74 Green LED 19

75 Blue LED 19

76 White LED 19

RGB RGBW

PHOTOMETRICS

Distance 1m:

26280,24 lx

6480 K

Ra 75

Measurements under laboratory

condions were made on

a spectrometer GL SPECTIS 1.0

R G B W

RGBW

FLASH-BUTRYM Sp.j.

Skarbimierzyce 18 · 72-002 Dołuje · POLAND

WWW.FLASH-BUTRYM.PL

FLASH F7100768 User manual

Brand: FLASH

Model: F7100768

Category: Stroboscopes & disco lights

Type: User manual

FLASH F7100768 is a professional LED moving head with powerful features, such as 19x15W 4-in-1 LEDs, a wide zoom range of 4° to 60°, and various control options for versatile use in stage lighting.

Download PDF

report

FLASH F7100768 User manual

FLASH F7100768 User manual

Related papers

Other documents