2. Dirtydog 4x4
  3. Pet Divider

Dirtydog 4x4 Pet Divider Installation guide

  • I have reviewed the installation instructions for the Dirtydog 4x4 pet divider, model DD-P-JK4-07. This document details how to install the divider using velcro wraps, shock cords, and hooks. I'm ready to answer your questions about the device described in this document.
  • How long does the initial installation take?
    What does the warranty cover?
    What is not covered under the warranty?
Installation Instructions
Pet divider for Jeep JK 2007-up
DD-P-JK4-07
-Thank you for purchasing a Dirtydog 4x4 netting system. Please
read these instructions fully to familiarize yourself with the
installation. Set aside 15 minutes for the first time you install your
pet divider.
First step is to install the velcro
wraps around the top roll bar.
Look at the photos to see how it is positioned along the roll
bar. The outermost straps on either endwraps around the roll
bar on the opposite side of the roll bar.
The two shock cords at the
back hook on to the loops
behind the seats.
The shock cord hooks at the
side hook on the underside
of the fender lip.
Dirtydog 4x4
3045 Southcreek Road
Mississauga, ON
Canada
416-704-0708
Question? Call or email [email protected]
Adjust and tighten straps as needed to even out the net so it is
positioned properly. Your pet divider comes with a one year warranty
against manufacturing defects. Cuts, abrasions, sun faded items are
not covered under the warranty.
/