AIO360G is a sensor for counting the number of people who enter and exit an entrance or passageway installedon the ceiling of the target area.
The movement of a person who passes under the sensor is recognized by our proprietary image processingtechnology,
and the number of people is counted for each direction.
The count results are recorded in the sensor every minute and transmitted to a specified server via LAN.
Recognizes and tracks the movements of people accurately therefore can omit people hovering near thecounting area
and provides an accurate traffic count.
Covers movements of the people in a wide area.
• Do not operate this product in such a way that a malfunction or failure could directly affect human life.
• If there is any abnormality such as smoke or an unusual smell from the product, stop
using it immediately.
• Do not drop or hit the product. If the product has been damaged, stop using itimmediately.
• Do not disassemble, modify, or repair the product. Doing so may cause fires and malfunctions.
• This product is class A information technology equipment. Using the product in a
household environment can cause electronic jamming. In such a case, the user
should take appropriate measures.
• Use the product with the cover firmly attached to prevent falling.
• This product is intended for indoor use only. Do not install outdoors.
• This product adheres to the PoE standards, however an electric discharge may occur when the device is hot-plugged.
We encourage you to protect the device by refraining from hot-plugging the device to avoid any breakdowns.
• This product cannot be used in general households.
• Do not install the product in the following places: (1) Places subject to direct sunlight,
(2) Places near fire or hot and humid places, (3) Places where condensation can occur,
(4) Places to which vibrations are transmitted directly, and (5) Places affected by rain or water.
• The inside of the product can reach a high temperature during operation.
• Do not pour or apply chemicals such as thinner, benzene, air freshener, orinsecticide on the product.
FCC Part 15 Subpart B Class A
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1)This device may not cause harmful interference.
(2)This device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment
is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if
not installed and used in accordance with the instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the
user will be required to correct the interference at his own expense.
Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority
to operate the equipment.
The CE marking indicates compliance to 2014/30/EU EMC Directive with Standards EN55032 Class A ;EN55035
Giken Trastem assumes no responsibility if the installation and wiring connection which are stated in the instruction
manual provided together with this product is not carried out, or when product without CE marking is connected to this device.
1
Haltian Thingsee Presence Installation guide
Vive 2Q7Y100 Operating instructions
Spin Master Zoomer Training manual
LG 27HJ712C-W Owner's manual
Crow DECT ULE SMK Installation guide
Visonic 425 Specification
ACTi Q960 Q961 Q962 Quick start guide
Sharp AQUOS PHONE SERIE SHL21 Owner's manual
OnePlus X User manual