Viking Range 17" Stainless Steel Professional Handle Kit Installation guide

Brand: Viking Range

Model: 17" Stainless Steel Professional Handle Kit

Type: Installation guide

INSTALLATION

INSTRUCTIONS

PROFESSIONAL SERIES HANDLE KIT

For Use with DFC Trash Compactor with Full Overlay Front

Retain for Future Reference

VIKING RANGE CORPORATION

111 FRONT STREET

GREENWOOD, MISSISSIPPI (MS) 38930 USA

(662) 455-1200

IMPORTANT-PLEASE READ AND FOLLOW

•Before beginning, please read these instructions completely and carefully.

•Do not remove permanently affixed labels, warnings, or plates from the product. This may void the warranty.

•Please refer to the Trash Compactor Installation Instructions for more information on installing the compactor door

panel.

•The installer should leave instructions with the consumer who should retain for local inspector’s use and for future

reference.

Parts included: Required Tools:

Professional Series Handle Electric Drill Phillips Head Screwdriver

(2) End Caps Pilot Bit Masking Tape

(4) 1/4” x 1 1/4” Phillips Head Screws 1/4” (.6 cm) Drill Bit Pencil

Installation Instructions Counter Sink Drill Bit Tape Measure

Rubber Mallet

INSTALLATION WITH WOODEN FULL OVERLAY CUSTOM DOOR FRONT

To Install:

1. Using the illustration on the right, layout the

handle location on the custom door. It is

recommended that masking tape be placed

where the four holes will be drilled to help

mark the hole placement and to prevent any

damage to the door when drilling the holes.

2. Drill small pilot holes completely through the

door at each of the four hole locations.

3. The Professional Series handle will be

mounted using the screws provided. These

screws require the holes to be countersunk on

the back of the panel in order for the storage

compartment cover plate to fit flush against

the compactor door panel. Using the four

pilot holes as guides, drill completely through

the door in the four hole locations with a 1/4”

(.6 cm) bit. Countersink the four holes on the

backside of the custom door panel.

4. Place a handle encap on both ends of the

handle tube. Tap the endcaps firmly into

place with a rubber mallet ensuring that both

endcaps mounting surfaces are parallel.

5. Align the holes in the endcaps with the holes

on the panel and attach the Professional

Series handle to the panel using the four

screws provided.

VIKING RANGE CORPORATION

111 Front Street • Greenwood,Mississippi (MS) 38930 USA • (662) 455-1200

Specifications subject to change without notice

For more product information, call 1-888-VIKING1 (845-4641) or visit our web site at http//www.vikingrange.com

(PS0903VR)

F20278

1/4” (0.6 cm)

hole locations

countersink

holes

(2) 1/32”

(.08 cm)

pilot holes,

1/4” (0.6

cm) deep

Custom Door - Back View

7-9/32”

(18.5 cm)

28-1/4”

(71.8 cm)

15”

(38.1 cm)

17-3/16” (43.7 cm)

1” (2.5 cm)

1-3/8”

(3.5 cm)

1-5/16”

(3.3 cm)

3/4” (1.9 cm) thick

Side View

Viking Range 17" Stainless Steel Professional Handle Kit Installation guide

Viking Range 17" Stainless Steel Professional Handle Kit Installation guide

Viking Range 17" Stainless Steel Professional Handle Kit Installation guide

Related papers

Other documents