Otterbox Defender Series User manual

Type
User manual
1Release corners and remove shield stand.
2Peel away and remove the outer slipcover.
3Separate the shell by locating the indicated arrows
and releasing each snap along all four sides.
4Place the device into the bottom half of the shell.
5Place the shell top half on the device and snap the
two pieces together along all edges.
6Wrap the slipcover around the shell. Ensure silcone
slipcover is nested in groove and notches on all
sides for a tight, secure fit.
Defender Series
Installation Instructions
7Comfortable typing.
8Media viewing.
9Portrait interaction.
10 Landscape streaming.
11
To release stand, move stand notch to the lowest
position and gently pull towards you, then slide
up to close stand tightly against back of case.
4 Working Positions
  • Page 1 1
  • Page 2 2

Otterbox Defender Series User manual

Type
User manual

Ask a question and I''ll find the answer in the document

Finding information in a document is now easier with AI